Instructions / Assembly

2
Should you encounter any problems, contact the Customer Service at [phone] from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.
Should you encounter any problems, contact the Customer Service at [phone] from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.
109
A. First, unplug the main power cord of the system.
B. Remove the Top Cover(5), Strainer Basket(23) and
Filter Cartridge(7) and remove any chlorine tablets
left inside the core section of the filter.
C. Loosen all Hose Clamps(12). Remove the Return Hose(13)
and allow water to drain out.
D. Remove the Pool Wall Fitting(15-21) and clean the parts
and lubricate Gasket(16) with petroleum jelly and reassemble
all parts then place them in a safe place.
E. Remove the motor(3) out by turning the Motor Seal Nut(1)
counter-clockwise. Now clean the pump, dry it off, and then
lubricate the Motor Seal(4) on the motor with petroleum
jelly and place it in a safe place.
F. Please refer to below illustration to reassemble the motor.
G. Remove the canister(9) from liner by turning the Skimmer
Seal Ring(22) counter-clockwise. Remove the Weir(8) and
Seal Rubber(24),. Clean all parts and dry them off. Then
reassemble the filter cartridge, strainer basket, weir, top cover,
etc. onto the canister. Place the assembled unit in a safe place.
IMPORTANT: THE PREFERRED METHOD IS TO DRAIN ENOUGH WATER FROM THE POOL FIRST THEN
DISMOUNT THE ENTIRE SKIMMER SYSTEM BEFORE REPLACEMENT. IF USER PREFER TO OPERATE IT ON THE
POOL, PLEASE REFER TO BELOW PROCESS. PLEASE NOTE INCORRECT HANDLING METHOD MAY CAUSE
WATER LEAKAGE BETWEEN CANISTER AND LINER.
7 POWER FILTER DISASSEMBLY AND STORAGE
8 MOTOR REPLACEMENT INSTRUCTION
1
Insert the Water Stopper into the water intake of pump. Push
the Stopper to make it engage with Skimmer Seal Ring (21)
closely.
3
Detach the Locking Ring (20) and Diverter Fitting (19)
by anticlockwise turning. Insert the Return Fitting Plug (21).
4
Remove Top Cover (5), Strainer Basket (22), Filter
Cartridge (7), it is advised to use a water container,
such as a bucket shown with dotted line in the
illustration to collect the water purged water
resulted from the pump servicing.
5
Remove the Motor Seal Nut (1) by turning according
to the arrow direction. Do not pull or push the canister
as you can to avoid engagement damage between
canister and pool liner.
6
Disassemble old motor and replace it
with new one.
7
Check the Motor Seal (4) from bottom side to make
sure it at the original slot correctly. Use left hand to
hold the motor from Canister inside. Make sure the
motor water outlet align with Canister outlet direction.
Then use right hand to tighten the Motor Seal Nut (1)
like the arrow direction (One more people help will
be easier for replacement).
Unplug the power.
Water Stopper
Skimmer Seal Ring
Motor Replacing or Reassembling
The two grooves should be
aligned when reassembling
skimmer canister
motor
alignment
mark
To make sure the motor engaged with
canister well, please make alignment
when replace or reassemble the motor.
Motor should fit with canister without
tilt or stuck situation.
keyway between
motor and canister
left hand
Motor Seal Gasket (2)
(motor water outlet)
Outlet of Canister. Make sure
align with motor water outlet.