Instructions / Assembly

IMPORTANT! Your filter pump is protected by a thermal switch. The switch senses the temperature of the filter pump. If it gets too hot, the switch will
stop the pump from running until it cools off. It will automatically turn back on when the filter pump has cooled down. This is a safety device to prevent
pump damage and prolong service life. If your pump is automatically turning off, it is because of high pool water temperature and/or low water flow
through the pump. If this happens you need to check the water flow and correct it if needed, as this filter pump uses the water flow for cooling. You
may also want to run the pump at night when the temperature is lower.
5. re-assemble in reverse order.
6. A spare “stand-by” Filter Cartridge 7 is an excellent investment. It provides a convenient way to continue filtration of your pool while cleaning or replacing a dirty
Filter Cartridge 7 . Also, a well-maintained, clean cartridge assures you that your filter will always be ready to operate at peak efficiency.
7. Filter cartridges may be purchased at the store you purchased your pool from, or ordered from Polygroup
®
. Always replace with genuine Polygroup
®
SUMMER
WAVES
™
filter cartridges.
2. Basic Cleaning: Clean the filter cartridge by throughly pressure
washing inside and out with a garden hose. Allow a few hours for the
filter to fully dry and CAREFULLY BRUSH the pleats (to avoid wear out,
do not scrub the pleated surface areas). Cleaning and scrubbing a filter
too vigorously will also wear out the cartridge much faster than if it is
simply hosed off correctly.
4. Excessive calcium and/or mineral deposits may build up on a filter cartridge
and should be handled differently. Contact your local pool supply store to ask
about additional filter cartridge cleaners or treatment for calcium or mineral
deposits. Check pool chemistry for high pH or alkalinity; this may cause a
calcium or mineral build-up.
3. To remove tough oils (e.g. suntan, bodyoils, algae, etc) it is recom-
mended to soak cartridge in a 1lb trisodium phosphate solution (or any
other strong detergent) to 5Ga water for up to 12hrs. Rinse cartridge to
remove dirt. To remove algae, add 1/2pint of pool chlorine or 1pint of
liquid household bleacher to the cleaning solution, 1 hour before retriev-
ing the cartridge. Thoroughly rinse before usage on filter case.
FILTER CARTRIDGE CLEANING AND REPLACEMENT
PUMP MOTOR PROTECTION
1. Check and adjust pH and chlorine levels daily using required chemicals. See Section “POOL WATER CARE”.
2. Check filter pump output daily. If flow is reduced, see Symptom 2 in Section “TROUBLE SHOOTING GUIDE”.
3. Check filter pump, hoses, fitting for leaks. If a leak is found, see Symptom 4 in Section “TROUBLE SHOOTING GUIDE”.
POOL MAINTENANCE
1. First, unplug (turn off) the Power Filter. Then remove the Top Cover 5 .
Remove the Strainer Basket 24 and the Filter Cartridge 7 .
24
7
5
11
OWNER’S MANUAL
Should you encounter any problems, contact Customer Service at [phone] from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.