Instructions / Assembly

TROUBLESHOOTING GUIDE
PROBLEM CAUSE
1. Motor fails to start or
kicks on and off
A Unit Not Plugged In
B GFCI Breaker Tripped
C Low Voltage
2. No flow or low flow
through return hose
A Low water level
B Inlet / Discharge Clogged
C Filter Dirty
3. Filter is not clearning
pool(water cloudy,
green,etc…)
A Chlorine Level does not
lie in the suitable range
B Filter Dirty
C pH Level does not lie in
the suitable range
D Cartridge Damaged
E Low Water Flow
F Other Chemicals Required
G Pool Water Very Dirty
4. Water Leakage
A Hose area : Return hose
does not fit well with skimmer
cuff and wall fitting elbow
B Bottom of canister:
Motor does not been screwed
tightly onto canister
C Between canister and
liner: Incorrect installation.
POOL PUMP DISASSEMBLY & STORAGE
1. First, unplug the main power cord of the system.
2. Remove the Top Cover 5 , Strainer Basket and Filter Cartridge 7 and remove any chlorine tablets left inside the core section of the filter.
3. Loosen all Hose Clamps . Remove the Return Hose and allow water to drain out.
4. Remove the Return Fitting - and clean the parts and lubricate Gasket with petroleum jelly and reassemble all parts then place them in a safe place.
5. Remove the Motor assembly 3 out by turning the Motor Seal Nut 1 counter-clockwise. Now clean the pump, dry it off, and then lubricate the Motor Seal 4
on the motor with petroleum jelly and place it in a safe place.
6. Please refer to below illustration to reassemble the motor.
7. Remove the Filter pump canister 9 from liner by turning the Skimmer Seal Ring counter-clockwise. Remove the Weir 8 and Strainer Basket . Clean all
parts and dry them off. Then reassemble the filter cartridge, strainer basket, weir, top cover, etc. onto the canister. Place the assembled unit in a safe place.
SOLUTION
A Plug the GFCI into a 3-wire grounded outlet.
B Reset circuit breaker. If problem persists, have an electrician to check circuit.
C Check the line voltage. It must be 105 to 125AC volts.
A Water level must be within the range of Water Limit Line marked on Skimmer canister.
B Check for obstructions at strainer basket and in return hose.
C Clean or replace cartridge. Spare cartridges make service more convenient.
A Maintain chlorine level between 1.0-1.6ppm.
B Clean or replace cartridge. Spare cartridges make service more convenient.
C Maintain pH level between 7.3-7.8.
D Replace cartridge.
E Check if obstructions at strainer basket and in return hose.
G Run pump more often, but never when pool is in use. Clean filter more often.
F Have water tested at pool supply store. It may be necessary to add other
chemcials due to varying water quality in different localities.
B Retighten the motor.
A Adjust hose clamp , check O-Ring and retighten. Check hose for any
holes or cracks. Replace if needed.
C Recheck the Seal Rubber with correct direction. The key feature should be at
top side and engage with canister ribs like the installation procedure described. Made sure
the liner should not be in the thread groove. Screw the Seal Ring as tight as can.
WARNING: UNPLUG THE POWER CORD BEFORE TROUBLESHOOTING THE FILTER PUMP.
13
OWNER’S MANUAL
Should you encounter any problems, contact Customer Service at [phone] from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.