Instructions / Assembly

SETUP INSTRUCTIONS
1. Set up the pool by following all instructions comes with the pool. Do not
fill water until the Filter Pump is properly installed. Locate the Skimmer
and Inlet openings on the pool wall.
3. Remove the Seal Ring by unthreading it counterclockwise Keep
Skimmer Gasket on its proper location.
5. Assemble the wall fitting parts according to the following schematic and
the Filter Pump Inlet.
6. Final assembly must look like the followingschematic.
2. Dismount the Skimmer Top Cover 5 and take out the parts contained
inside.
4. Ater placing the threaded intake of the skimmer inside its corresponding
pool hole, screw back the seal ring tightly on its place.
WARNING: POSITION THIS PRODUCT AWAY FROM THE POOL, SO AS TO PREVENT CHILDREN FROM CLIMBING ON IT AND ACCESSING THE POOL.
Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
Make sure the key
featureis facing the
correct location.
No obvious gap must
be noticed in this zone.
Make sure the two rubber keyways
are properly located after installation.
Make sure the pool liner lies
on this round surface, not fall
into the thread slots. It may
cause water seepage.
thread slots
Make sure the hose clamp
is located at the right over the
O-Ring location,to ensure
proper sealing.
canister
Hose end align
with the step
Inlet
opening
Skimmer opening
9
OWNER’S MANUAL
Should you encounter any problems, contact Customer Service at [phone] from 8 AM to 5 PM Mon. thru Fri.
EST. Extended operating days and hours during peak season requirements.