User Manual

Fig. 1: Field Position Fig. 2: Transport Position
Themachineshouldbeplacedinanareathatallowsampleroomforassemblyineldposition(See
Fig. 1).
CAUTION: For safety purposes, block equipment while working on it.
HITCH – Axles, Wheels and Jack
Attach hitch hydraulic depth adjustment and axle assemblies as shown on page 2-2 through page 2-5.
Mount hitch wheels and tires and install hitch jack.
DRAWBAR: Center, Hydraulic Lift Cylinders, Wings, Axles and Wheels.
Attachcenterdrawbartohitchusingtwo1-1/4”X6”pinsandsecurewithatwashersand5/16”X
2-1/2” cotter pins. Mount main lift cylinders and transport locks. Route hoses as shown on page
2-7.Fullychargemainliftcylinderswithhydraulicuidbyextendingandretractinguntilallairis
purged from system.
Attach wing drawbars to knuckles using 1-1/2” X 11” pins. Secure with 1/2” X 2-1/2” bolt, washer and
lock nut. Install 1-1/2” jam nut, center punch or spot weld to secure. Attach jack mounting swivels
onthetopofwingnearknuckleineldposition.Securewith7/8”u-bolt,lockwashersandnuts.
Mount wing hydraulic depth adjustment assemblies as shown on page 2-5. Mount wing wheels
and tires.
HYDRAULIC SYSTEMS
Mount Auto-Fold lock, cylinder and hoses as shown on page 2-7.
NOTE: The tractor hydraulic control valve operating Auto-Fold lock cylinder must hold pressure. If
Auto-Foldlockcylinderextendsduringeldoperation,damagewilloccur,thisdamageisnotcov-
ered by warranty
Mount Hydraulic Depth Adjustment cylinders and route hoses as shown on page 2-9 and photos
on page 2-10. Allow enough hose at hinge points to avoid pinching or stretching hose. Clamps
(8W1398) are provided to secure hydraulic hoses to drawbar. Attach hydraulic hose holder to rear
hitchcrosstubewith3/4”X1-1/4”hexheadcapscrewandatwashersprovided.Routehoses
through loop to prevent ground contact in transport position. Bend loop closed to secure hoses.
SECTION 2 - SUPERHARROW PLUS
2-1
SET-UP INSTRUCTIONS