User Manual
Fig. 8
The two front outside teeth on the center section (closest to knuckles) must be secured with PN
8HD6150 (ANGLE, tooth stop) and 1/2” X 3-3/4” cap screws as shown in Fig. 9. This prevents
interference in transport position.
TRANSPORT WHEELS
Locate transport wheel assemblies over end har-
row section on 36 through 60 ft. machines with
pivot tube in higher position. Install between end
section and second section on 72 ft. and over sec-
ond section on 84 ft., both with pivot tube in lower
position. Secure with 7/8” U-bolts and hardware.
Transport axle “toe-in” can be adjusted with the
outside stop set bolt (8X0665, Page 2-8). Adjust
inside stop bolt 3/8” away from pivot plate when
resting on outside stop bolt. This adjustment will
allow transport wheel to pivot inward while unfold-
ing. Double lock stop bolts with 3/4” jam nuts provided.
AUTO-CABLE FOLD
Mount Auto-Fold pivot brackets ahead of welded stop. Do not fully tighten U-bolts. Attach left and
right cable fold arms to pivot brackets with 1-1/4” X 14” pins and hardware.
Adjust pivot brackets to provide clearance between the cable fold arm bottom guide and hitch tube.
This adjustment is made with 3/4” X 2-1/4” bolts (8X0112, Page 2-8). This adjustment will allow cable
fold arms to pivot freely into transport position. Fully tighten mounting U-bolts after adjustment is made.
Attach tension springs with 3/4” eye bolts and lock nuts. Tighten eye bolts until spring coils begin to
separate.
CABLES
Install cable brackets and cable assemblies. Adjust cables so wings slightly lead the center. Tighten
attachmentU-bolt.Rechecktightnessafterrsthourofelduse.Installrearcablesasshownon
page 2-14. 72’ and 84’ SuperHarrow Plus ONLY: Install Cable Guides as shown on Page 2-15.
HYDRAULIC TINE ANGLE OPTION:
See following Set-Up Instructions and parts breakdown pages 2-16 through 2-24 and layout on
page 2-6.
Wing Section Lower Stop Bolt Location
Center Section Stop Bolt Location
(shown installed)
Fig. 9: ANGLE, tooth stop
SECTION 2 - SUPERHARROW PLUS
2-11