User Manual

SECTION 3 - SUPERHARROW 2650
3-19
FIELD TO TRANSPORT POSITION
1. Stop in a level area and back tractor up to provide slack in pull cables.
2. Open manual lock valve on auto-fold lock cylinder. Fully extend auto-fold lock cylinder.
3. Fully retract Hydraulic Depth Adjust cylinders.
4. Fully retract lift cylinders raising sections.
5. While machine is resting on its transport wheels, drive tractor forward. Wings should fold to transport
position. NOTE: Transport wheels must rotate against “toe-in” adjustment cap screws and follow
directly behind knuckles. Transport wheel “toe-in” can be adjusted by moving outside 3/4” adjust-
ment set screws (8X0665, Page 3-5). “Toe-in” and proper lubrication of pivot will make it easier
tounfoldmachineintoeldposition.Wingsupportwheelsmustnotcontactintransportposition.
6. IMPORTANT: Install transport locks.
UNHITCHING MACHINE
1. Park machine on a level area. Block wheels to prevent machine from rolling.
2. Follow steps outlined in WARNING – NEGATIVE HITCH WEIGHT on page 1-2.
SUMMERS SUPERHARROW 2650 PERFORMANCE ADJUSTMENTS:
NOTE:Thesearesuggestedinitialsettings,furtheradjustmentsmaybenecessarytomatcheld
conditions.