Specification Sheet
WALL MOUNTED VENT HOOD SPACER
Read and follow all instructions. The SSVH-SPT/SP4/SP8 series wall mounted spacers must be secured into multiple
wall studs using proper hardware to ensure sufficient load support. Metal framework will require additional wall studs
and screws for appropriate support. Installation must be done by a qualified professional installer. Please review and
understand this section prior to proceeding with installation.
Aer the wall mounted spacer is secured into its permanent location, untighten and remove all hex nuts from the
mounting hex cap screws. All mounting hardware are pre-installed with the spacer. Ensure that the filler plates
remain intact (see figure below).
Aach the vent hood directly into the spacer through the mounting holes located on the rear hood cover plate. Fasten
and tighten all hex nuts. Reference the parts list below to identify the hardware included with your wall mount spacer.
PN: 90151
REV A
12/20
Description SSVH-36 SSVH-48 SSVH-60
1/2” Mounting plate SSVH-36-SPT SSVH-48-SPT SSVH-60-SPT
4” Vent Hood Spacer SSVH-36-SP4 SSVH-48-SP4 SSVH-60-SP4
8” Vent Hood Spacer SSVH-36-SP8 SSVH-48-SP8 SSVH-60-SP8
Item Description QTY
1 5/16-18x1 SS Hex Head Cap Screw 12
2 5/16 - 18 SS Hex Nut 12
3 5/16 - 18 SS Flat Washer 24
4 5/16 - 18-8 SS Split Lock Washer 12
5 Filler Plate 2
** Instruction Sheet 1
SPECIFICALLY DESIGNED FOR SUMMERSET VENT HOOD MODELS: SSVH36 / SSVH48 / SSVH60