Instruction Manual

Table Of Contents

Full Overlay Panel Installation Instructions (ADRD15)

This model is designed for a field-installed overlay panel,

which can cover the stainless steel to give a built-in

appearance. The overlay panel and appropriate hardware

are not included with the appliance, and you must install

the panel yourself.

Please follow the instructions below for installation:

Remove any items stored inside the drawers, and take

the drawers out.

Peel off the gasket, and remove the handle by

removing the two screws that attach the handle to the

door.

Drill the 8 holes shown by using a 9/50” drill bit on the 4

sides of drawer door front. (Fig.2)

Cut the overlay panels with 3/4” thickness to the

following dimensions: 14.88” x 14.17”(HxW).

If reusing the handles that came with the appliance, drill

two holes with diameter 9/50” in the overlay panel.

If user-supplied handles will be used, attach the

handles to the overlay panels by using the flat head

screws and drive the screws flush with the panels.

Attach the handle and overlay panel together to the

drawer face using 2 M4x45 screws and through the 2

existing holes on the door face. Then attach the overlay

panel to the drawer face using 8 M4x45 screws and

through 8 existing holes inside the door groove. (Fig. 3)

Attach the overlay panel to the drawer face through the

existing holes inside the door groove, using the 8

M4x45 screws.

Peel back the gaskets, then align the left and right side

channels with the tracks in the cabinet. Ensuring an

even track engagement on both sides, gently push the

drawer into the cabinet until it stops.