Instruction Manual
Table Of Contents
- FROST-FREE DRAWER REFRIGERATOR
- TABLE OF CONTENTS
- APPLIANCE SAFETY
- IMPORTANT SAFEGUARDS
- LOCATION OF PARTS
- INSTALLATION INSTRUCTIONS
- Before Using your Appliance
- Installation of your Appliance
- Electrical Connection
- Anti-Tip Bracket Installation
- Drawer Divider Installation (for ADRD24)
- Installing the Stainless Steel Handles
- Full Overlay Panel Installation Instructions (ADRD24)
- Full Overlay Panel Installation Instructions (ADRD15)
- Stainless Steel Kick Plate Installation Instructions
- OPERATING YOUR APPLIANCE
- CARE AND MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
- INFORMATION SUR LA SÉCURITÉ
- GARANTIES IMPORTANTES
- INSTALLATION DE VOTRE CONGÉLATEUR DROIT
- Avant d'utiliser votre appareil
- Installation de votre appareil
- Connexion électrique
- Installation du support anti-basculement
- Installation du diviseur de tiroir (pour ADRD24)
- Installation des poignées en acier inoxydable
- Instructions d'installation du panneau de superposition complete (ADRD24)
- Instructions d'installation du panneau de superposition complete (ADRD15)
- Instructions d'installation de la plaque de protection en acier inoxydable
- FONCTIONNEMENT DE VOTRE APPAREIL
- SOINS ET ENTRETIEN
- DÉPANNAGE
- REMARQUES
8
Drawer Divider Installation (for ADRD24)
In order to make better use of the drawer to store different drinks or fruits, the ADRD24 model is
equipped with two sets of drawer dividers.
1. Please find the divider accessories in the accessory plastic bag, the details of the
accessories are as follows:
Divider permanent seat (Left) 2pcs
Divider permanent seat (Right)
2pcs
Movable divider
(2 rotators, 2 U-shaped tubes)
2sets
Upper drawer S.S. pipe 2pcs
Lower drawer S.S. pipe
2pcs
2. Please follow the steps in the figure to install.
Step 1: To install 1pce right and 1pce left divider permanent seat on the two side on upper
drawer (figure 1) and lower drawer (figure 2)
Step 2: To assemble the movable divider, the parts that need to be prepared are 2pcs upper
drawer pipe, 2 U-shaped tubes and 2 rotators, please following below figure 3.
Figure 3