Ice Maker Model BIM24SS Instruction Manual Write Serial Number of unit here: ____________________________ Felix Storch, Inc. Summit Appliance Division 770 Garrison Avenue Bronx, New York 10474 www.summitappliance.
IMPORTANT SAFETY INSTRUCTIONS TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY WHEN USING YOUR ICE MAKER, FOLLOW THESE BASIC PRECAUTIONS: WARNING • • • READ ALL INSTRUCTIONS BEFORE USING THE ICE MAKER. NEVER CLEAN ICE MAKER PARTS WITH FLAMMABLE FLUIDS. THE FUMES CAN CREATE A FIRE HAZARD OR EXPLOSION. DO NOT STORE OR USE GASOLINE OR ANY OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER ICE MAKER. THE FUMES CAN CREATE A FIRE HAZARD OR EXPLOSION.
INSTALLATION INSTRUCTIONS Before Using Your Ice Maker • • • • Remove the exterior and interior packing. Check to be sure you have all of the following parts: 1 removable ice bin 1 plastic scoop 25 ft. hose 1 instruction manual Before connecting the ice maker to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Clean the interior surface with lukewarm water using a soft cloth.
• To prevent accidental injury, the cord should be secured behind the ice maker and not left exposed or dangling. Extension Cord Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this appliance.
OPERATING YOUR ICE MAKER Initial Start-Up Operation 1. Plug the appliance into a 115/120V AC polarized and grounded wall electrical outlet. 2. Place the ON-OFF switch in the ON position. 3. Make sure the water supply is on. As soon as the inner mechanism reaches the proper temperature, the icemaker mechanism will fill the mold with water. 4. The first cubes may be small because of air in the water line. Later cubes will be of standard crescentmoon shape. 5.
CARE AND MAINTENANCE Cleaning Your Ice Maker • Turn the switch control to OFF, unplug the ice maker and remove the ice bin. • Wash the inside with a warm water and baking soda solution. The solution should consist of about 2 tablespoons of baking soda to a quart of water. • Wash the ice bin with a mild detergent solution. • The outer cabinet of the ice maker should be cleaned with mild detergent and warm water. Clean the door and handle with an approved stainless steel cleaning product.
PROBLEMS WITH YOUR ICE MAKER You can solve many common ice maker problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the service technician. Troubleshooting Guide PROBLEM Ice maker does not operate. POSSIBLE CAUSE Not producing ice Compressor turns on and off frequently. Vibrations The ice maker seems to make too much noise. The door will not close properly. Ice cubes are melted together. Not plugged in.
SUMMIT® LIMITED WARRANTY SUMMIT® Appliance warrants this product to be free from defects in materials and workmanship for a period of one year from the date of original purchase or delivery. Any parts determined to be defective will be replaced by SUMMIT® at no charge to you. Plastic parts and outer cabinets are warranted to be manufactured to commercially acceptable standards and free from defects at the time of delivery.