BEVERAGE MERCHANDISERS Model Nos.: CL156BV / CL186BV / CL24BV Instruction Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS.
TABLE OF CONTENTS Appliance Safety 3 Important Safeguards 3-5 Disposal 5 Location of Parts 6-7 Installation Instructions 8-11 Before Using your Appliance 8 Installation of your Appliance 8 Electrical Connection 9 Anti-Tip Bracket 10 Installing the Stainless Steel Handle 10 Operating your Appliance 11-13 Control Panel 11-12 Interior Light 12 Sabbath Mode 12 Temperature Memory Function 12 Temperature Alarm/Door Alarm 12 Shelves 13 Defrosting 13 Care and Maintenance 13-14
APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words "DANGER" or "WARNING".
• • • • • • • • • • • • • • • • • • • • • • • • In the event of any damage: - Avoid open flames and anything that creates a spark, - Disconnect from the electrical power line, - Air the room in which the appliance is located for several minutes and - Contact the Service Department for advice. The more coolant there is in an appliance, the larger the room it should be installed in. In the event of a leakage, if the appliance is in a small room, there is the danger of combustible gases building up.
Risk of child entrapment! Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous, even if they will “just sit in the garage a few days”. Before discarding your old refrigerator: • Take off the door • Leave the shelves in place so that children may not easily climb inside. - SAVE THESE INSTRUCTIONS - DISPOSAL Dispose of your appliance packaging properly. Ensure that any plastic wrappings, bags, etc.
LOCATION OF PARTS Model CL156BV Model CL186BV 6
Model CL24BV INSTALLATION INSTRUCTIONS 7
Before Using the Appliance • Remove the exterior and interior packing. CAUTION: After unpacking you MUST allow this appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so may adversely affect performance and the lifetime of this unit. • Clean the interior surface with lukewarm water using a soft cloth. • Install the handle on the door. (See page 10.
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug that mates with standard three-prong wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For personal safety, this appliance must be properly grounded. This appliance requires a standard 115/120 Volt AC ~60Hz three-prong grounded electrical outlet.
To reduce the risk of tipping the unit by abnormal usage or improper loading, the appliance must be secured by properly installing the anti-tip device packed with the appliance. • • • • • Place the anti-tip bracket on the floor as shown in the figure. An anti-tip bracket must be installed at the left side. Mark the locations of the 4 holes of the anti-tip bracket on the floor. Use a 5/16” masonry drill bit and insert plastic anchors. Secure bracket to floor using screws.
It is recommended that you install the appliance in a place where the ambient temperature is between 72º and 78ºF (23º to 26ºC). If the ambient temperature is above or below the recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate. The range of 36º to 43ºF (2º to 6ºC) may not be reached. Control Panel ON/OFF Power • To turn the appliance off, press and hold the goes out.
Interior Light • • The interior light makes it easy to view your stored items and enhances the display of your collection. The LIGHT switch allows you to toggle between 2 modes of operation for the internal lights: functional (default) mode and showcase mode. If you are in functional (default) mode (also named Energy Saving Mode), the lights will turn on only when the door is open. If you are in showcase mode, the lights will be on whether or not the door is open.
To prevent damaging the door gasket, make sure to have the door all the way open when pulling the shelves out of the rail compartment. • For easy access to the stored contents, you can pull the shelf approximately halfway out of the rail compartment. This unit was designed with a plastic post on each side of the shelf track to prevent shelf contents from falling. • When removing the shelf from the inner rails, make sure to remove all shelf contents first.
2. 3. 4. 5. Securely tape down all loose items (shelves) inside your appliance. Turn the adjustable legs up to the base to avoid damage. Tape the door shut. Be sure the appliance stays secure in the upright position during transportation. Also, protect the outside of the appliance with a blanket or similar item. Energy-Saving Tips • • • The appliance should be located in the coolest area of the room, away from heat-producing appliances and out of direct sunlight.
Vibrations The appliance seems to make too much noise. • Tripped circuit breaker or a blown fuse. • The light was switched off on the control panel. • The appliance is not properly leveled. • Switch on circuit breaker or replace fuse. • Switch on the light. • Level the appliance with the adjustable feet. A rattling noise may come from the flow of the refrigerant, which is normal. As each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your appliance.
ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
