Installation Guide

3
FOLLOW WARNING CALLOUTS BELOW ONLY WHEN APPLICABLE TO YOUR MODEL
 This appliance is only intended for residential cooking. The manufacturer cannot be held responsible
for damage or injury caused by improper use or for uses other than those for which this appliance is
intended.
 Do not touch hot surfaces. Use handles or knobs.
 To protect against electrical shock do not immerse cord, plug, or body of unit in water or other liquid.
 Close supervision is necessary when any appliance is used by or near children.
 Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off
parts.
 Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has
been damaged in any manner. Return appliance to the nearest authorized service facility for
examination, repair, or adjustment.
 The use of accessory attachments not recommended by the appliance manufacturer may cause
injuries.
 Do not use outdoors.
 Do not let cord hang over edge of table or counter, or touch hot surfaces.
 Do not place on or near a hot gas or electric burner, or in a heated oven.
 Extreme caution must be used when moving an appliance containing hot oil or other hot liquids.
 Always attach plug to appliance first, then plug cord into the wall outlet. To disconnect, turn any
control to "OFF”, then remove plug from wall outlet.
 Do Not Cook on Broken Cooktop - If cooktop should break, cleaning solutions and spillovers may
penetrate the broken cooktop and create a risk of electric shock.
 Clean Cooktop with Caution - If a wet sponge or cloth is used to wipe spills on a hot cooking area, be
careful to avoid steam burns. Some cleaners can produce noxious fumes if applied to a hot surface.
 The appliance must be installed with all electrical, water and drain connections in accordance with
state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in
accordance with the National Electrical Code and local codes and ordinances, is required.
 Do not kink or pinch the power supply cord of the appliance.
 The size of the fuse (or circuit breaker) should be 20 amperes.
 Proper Installation - Be sure your appliance is properly installed, per the manufacturer instructions.
 Never use your appliance for warming or heating the room.
 Do Not Leave Children Alone - Children should not be left alone or unattended in area where the
appliance is in use. They should never be allowed to sit or stand on any part of the appliance.
 Use Proper Pan Size - This appliance is equipped with one or more surface units of different size.
Select utensils having flat bottoms large enough to cover the surface unit heating element. The use
of undersized utensils will expose a portion of the heating element to direct contact and may result in
ignition of clothing. Proper relationship of utensil to burner will also improve efficiency.
 Never Leave Surface Units Unattended at High Heat Settings – Boil-over causes smoking and greasy
spillovers that may ignite and can create a Fire Hazard.
 Do Not Touch Heating Elements or Areas Near Heating Elements - Heating elements may be hot
even though they are dark in color. Areas near heating elements may become hot enough to cause
burns. During and after use, do not touch or let clothing or other flammable materials contact heating
elements or areas near heating elements until they have had sufficient time to cool. Among these
areas are the cooktop and surfaces facing the cooktop.
 Use this appliance only for its intended purpose as described in this Owner’s Manual.
- SAVE THESE INSTRUCTIONS -