FROST-FREE REFRIGERATOR-FREEZER FF1116W series Models CM405 FF1117BL CM411Lseries FF1158SS series CM421BL Owner's Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Write the Model and Serial Numbers here: _________________________ _________________________ FELIX STORCH, INC. 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
IMPORTANT SAFEGUARDS Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words ”DANGER” or “WARNING”.
• This unit is not designed to operate in enclosed spaces. When placing your unit, make sure you allow adequate airflow on all sides. • Use two or more people to move and install the refrigerator. Failure to do so can result in back or other injury. • To ensure proper ventilation for your refrigerator, the front of the unit must be completely ° ° unobstructed. Choose a well-ventilated area with temperatures above 60 F (16 C) and below ° ° 90 F (32 C).
Table of Contents Important Safeguards ....................................................................................................1 - 2 Location of Parts ................................................................................................................. 3 Technical Information ......................................................................................................... 4 Installation Instructions .............................................................................
Technical Information Models: Capacity: Electrical Input: Rated Current: Energy Consumption: Energy Star approved: Refrigerant: Installation: Shipping Weight: Unit Dimensions: FF1116W (white) FF1117BL (black) FF1158SS (black cabinet with stainless steel door) 10.3 cubic feet 115V AC / 60Hz 1.6A 313 kWh/yr Yes R134a, 5.3 oz Free-standing 166 lbs 23.63"W x 26.0"D x 58.88"H Installation Instructions Before Using Your Appliance: • Remove the exterior and interior packing.
may increase electrical consumption. Extremely cold ambient temperatures may also affect the unit's performance. • Avoid locating the unit in moist areas. • Plug the unit into an exclusive, properly installed and grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or authorized service center.
Reversing the Door Swing: The doors of the refrigerator-freezer can be hinged on either side so that the door swing can be suited to the location of the installation. Tools Required: • standard screwdriver • large Phillips head screwdriver • socket wrench (3/8") In order to reverse the position of the door hinges, refer to the disassembly diagram below and follow this procedure. 1. Remove the hinge cap by twisting it off. 2. Remove the upper hexagonal-head screws.
5. Tilt the refrigerator back or lay it on its back for steps 6, 7 and 8. Use a pad or blanket to protect the floor and to avoid scratching the painted finish. 6. Remove the leveling legs by turning them counterclockwise. Remove the lower hexagonal-head screws, two on the hinge side and one near the front corner of the other side. 7. Attach the bottom hinge symmetrically to the other side of the cabinet with the screws removed in Step 6. (Do not tighten screws completely.) 8.
Operating Your Refrigerator Setting the Temperature Controls: Your unit has one control for regulating the temperature in the refrigerator compartment and a separate one for the freezer. Refrigerator: The refrigerator compartment's temperature control (thermostat) is a dial type located at the top center of the compartment. TURN KNOB BOTTOM VIEW KNOB • When you turn the unit on for the first time, set the control to its coldest setting, which is MAX.
behind the wall). During the compressor's off-cycle, the ice will melt, drip down, and drain through a small hole behind the crisper into a tray above the compressor where the compressor's heat evaporates the water. If you notice an excessive build-up of ice on the rear wall of either the refrigerator or the freezer compartment, try setting the thermostat to a slightly warmer setting. Be sure the door gasket is well seated.
Care and Maintenance Cleaning Your Refrigerator: 1. Unplug the unit and remove the food, shelves and crisper. 2. Wash the inside surfaces with a solution of warm water and baking soda. The solution should contain about 2 tablespoons of baking soda to a quart of water. Rinse and dry thoroughly with a clean soft cloth. 3. Wash the shelves and crisper with a mild detergent solution. Rinse and dry. 4. Wash the outside cabinet with warm water and mild liquid detergent.
Moving Your Unit: 1. 2. 3. 4. 5. Remove all the food. Securely tape down all loose items inside your unit. Turn the leveling legs up to the base to avoid damage. Tape the doors shut. Be sure the unit stays secure in the upright position during transportation. Also, protect the outside of the unit with a blanket or similar covering. Energy-Saving Tips: • • • • • The unit should be located in the coolest area of the room, away from heatproducing appliances and out of direct sunlight.
Troubleshooting You can easily solve many common problems with your appliance, saving you the cost of a possible service call. Try the suggestions below to see if you can correct the problem before calling the service provider. TROUBLESHOOTING GUIDE Problem Possible Cause Unit does not operate. Not plugged in. The circuit breaker has tripped or the fuse has blown. Turns on and off frequently. Room temperature is warmer than usual. A large amount of food has been added to the unit.
Limited Warranty ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
