Use and Care Manual

17
For the model SCR312LPUB series, install the handle as follows:
1. Remove the door gasket on the side you wish to
install the handle - you can see two designated
holes for handle installation. The gasket is easily
displaced by hand; no tools are necessary.
2. Install the handle tightly as shown with two screws,
lock washers and flat washers provided. (DO NOT
over tighten as this will cause damage to the handle
and stainless steel door frame).
3. Replace the door gasket to its original position.
For the model SCR2466PUB series, the handle installation directions are included in the
instructions for reversing the door swing.
The model FF29KDTPUB series does not have a removable handle.
Operating Your Pub Cellar
Digital Thermostat:
The temperature inside your appliance is controlled by a digital thermostat located at the
front of the unit. Normally, the LED display shows the current temperature inside the
unit.
The preset temperature range of the thermostat is 41 to 65ºF (5 to18°C) except for the
SCR2466PUB models where the range is 41 to 72°F (5 to 22°C). The operating
temperature is factory-set at 45ºF (7°C). If you find that it is necessary to change the
temperature setting (Set Point) for your appliance, refer to the appropriate instructions
below.
 Series models FF7LBLPUB, FF29KDTPUB, FF63BDTPUB and SCR600BLPUB:
The front panel of the thermostat for these models is illustrated here:
To see the SET POINT:
Push and immediately release the SET key. The display will show the Set Point
value. Wait 5 seconds and the interior temperature will display again.
To change the SET POINT:
1. Push and hold the SET key for more than 3 seconds to change the Set Point
value. The value of the Set Point will be displayed.
Handle
Door Frame
Gasket
Screw
Lock Washer
Flat Washer