Use and Care Manual

19
ON/OFF Power
Connect the power cord to a properly grounded outlet. To turn the appliance on or off,
press the ON/OFF button.
NOTE: This unit has a protective delay function. The compressor will start to work about
3 to 5 minutes after it is powered on.
RUN Light
This light indicates when the compressor is working. While the compressor is operating,
the red light is on. During down time in the operating cycle, this light is off.
SETTING Window
Displays the temperature you set. The range of temperature setting is 41 to 72 degrees
Fahrenheit (5 to 22°C).
CHAMBER Window
Displays the temperature inside the cabinet. The range of the temperature display is 32
to 99 degrees Fahrenheit (0 to 37°C).
SET Button
Temperature setting button; once you press the button, the temperature increases 1°C
or 1°F. Setting range is between 41 and 72 degrees Fahrenheit (5 to 22°C).
Light Button
You can turn the interior light on or off by pushing the button marked LIGHT.
NOTE: The light goes off automatically after 10 minutes.
°C/°F Button
Celsius / Fahrenheit conversion button
Shelves for SCR2466PUB models:
SCR2466PUB series models are equipped with 2 wire beverage shelves, 1 glass
beverage shelf and 1 wooden wine bottle shelf.
To prevent damaging the door gasket, be sure the door is open all the way when
pulling a shelf out of the rail compartment.
For easy access to the stored contents, you can pull the shelf approximately 30% out
of the rail compartment. The unit was designed with a stopper on each side of the
shelf track to prevent the shelf from pulling out all the way, allowing bottles to fall.
You can remove each beverage shelf (wired and glass) by first emptying the shelf,
then lifting up and pulling it out smoothly.
To remove the wooden wine shelf, pull the shelf out as far as it will go. Use a long
flat screwdriver to press down the right plastic notch as shown in Figure A (on the
next page) and at the same time lift the left plastic notch as shown in Figure B. Then
proceed to pull out the shelf slowly. Contact our service department if assistance is
needed.