Instruction Manual

4
any other appliance. The fumes can create a fire hazard or explosion.
 Use two or more people to move/install the refrigerator. Failure to do so can result in back or
other injury.
 The appliance should not be located next to ovens, grills or other sources of high heat.
 The appliance must be installed with all electrical connections in accordance with state and
local codes. A standard electrical supply (115V AC 60 Hz), properly grounded in accordance
with the National Electrical Code and local codes and ordinances, is required.
 Do not kink or pinch the power supply cord of the appliance.
 The fuse (or circuit breaker) size should be 10 amps or higher.
 It is important for the appliance to be leveled in order to work properly. You may need to make
several adjustments to level it.
 Although the unit has been tested at the factory, due to transit and storage, you should clean
the appliance before use.
 Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may
damage or discolor the interior.
 This appliance is CFC- and HFC-free and contains small quantities of Isobutane (R600a) which
is environmentally friendly, but flammable. It does not damage the ozone layer, nor does it
increase the greenhouse effect. Care must be taken during transportation and setting up of the
appliance that no parts of the cooling system are damaged. Leaking coolant can ignite and may
damage the eyes.
 In the event of any damage:
- Avoid open flames and anything that creates a spark,
- Disconnect from the electrical power line,
- Air the room in which the appliance is located for several minutes, and
- Contact the Service Department for advice.
 The more coolant there is in an appliance, the larger the room it should be installed in. In the
event of a leakage, if the appliance is in a small room, there is the danger of combustible gases
building up. For every ounce of coolant, at least 325 cubic feet of room space is required. The
amount of coolant in the appliance is stated on the data plate on the back of the appliance. It is
hazardous for anyone other than an authorized Service Person to carry out servicing or repairs
to this appliance.
 Take serious care when handling, moving, and using the appliance to avoid either damaging
the refrigerant tubing or increasing the risk of a leak.