Instruction Manual

Light / Lock

 LED lamp brightness mode: with Memory IC (when unit restarts after power failure unit, will

auto recover to last setting), the default brightness is 100%.

Each time the button is pressed, the brightness of the LED will be cycled through the

four positions (100%, 75%, 50%, OFF)

 Press and hold for 3 seconds to lock or unlock the control panel.

ON/OFF Power / Mute

 To turn the appliance on or off, press and hold the ON/OFF button for 3 seconds.

 When the high/low temperature alarm is activated, the buzzer will sound continuously. Press

one time to turn off the alarm.

LOCK

If illuminated, indicates the control panel is locked.

RUN

When unit’s compressor is running, this indicator light will illuminate to signify that cooling mode is

currently in operation.

Demo mode

 Press and hold buttons , and simultaneously for 10 seconds to enter or exit

demo mode.

 In this mode, the display panel can operate settings, but the temperature is a fixed display 12°C

(54°F) and all fans plus the compressor will not start.

Defrosting

 The unit defrosts automatically in normal operating conditions.

 The evaporator behind the rear wall of the unit defrosts automatically. Water will drain through

the drain pipe from the back of the product. Users need to bring the water to the drain or find an

appliance to load the water. (If loading with an appliance, you need to pay attention to clearing

the water regularly)

 However, frost may accumulate on the evaporator if the unit is repeatedly opened in a high

heat or high humidity location. If this frost pattern does not clear within 24 hours, your unit will

require manual defrosting.

Mandatory defrost mode: Press the and at one time for 10 seconds to enter the

compulsory defrost mode.

NOTE:

 If the unit is unplugged or turned off, or if there has been a power failure, you must wait 5

minutes before restarting the unit. If you attempt to restart before this time delay, the appliance

will not start.