TWO-ZONE WINE COOLERS Models SWC902D SWC1380D Owner’s Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Write Model and Serial Numbers here: _________________________ _________________________ Felix Storch, Inc. Summit Appliance Division An ISO 9001:2015 registered company 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
IMPORTANT SAFETY INSTRUCTIONS WARNING To reduce the risk of fire, electrical shock or injury when using your appliance, follow these basic precautions Read all instructions before using the wine cooler. Plug into a grounded 3-prong outlet. Do not remove grounding prong, do not use an adapter, and do not use an extension cord. It is recommended that a separate circuit, serving only your wine cooler, be provided. Use receptacles that cannot be turned off by a switch or pull chain.
Although the unit has been tested at the factory, due to transit and storage, you should clean the appliance before use. Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may damage or discolor the interior. Do not use this apparatus for other than residential purposes. This appliance is CFC- and HFC-free and contains a small quantity of Isobutane (R600a) which is environmentally friendly, but flammable.
TABLE OF CONTENTS Important Safety Instructions .................................................................... 1 – 2 Location of Parts ............................................................................................... 4 Installation Instructions................................................................................. 5 - 7 Before using your wine cooler .................................................................. 5 Installation of your wine cooler ............................
LOCATION OF PARTS Upper hinge Upper zone Glass door Control panel Full-size wooden shelves Handle Lower zone Baffle plate Short wooden shelf Key lock Ventilation grille (kickplate) Door seal (gasket) Adjustable legs NOTE: Each zone has a Ventilation fan and a Sensor located on the rear wall. An Active carbon filter is installed in the rear wall of the upper zone. This filter improves air purity and cooling efficiency, and helps maintain an odor-free environment for the stored wine.
INSTALLATION INSTRUCTIONS Before Using Your Wine Cooler Remove the exterior and interior packing. Before connecting the wine cooler to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Clean the interior surface with lukewarm water using a soft cloth. This cooler is specifically designed for the storage of wine – do not use it for other purposes.
6
NOTE: All parts removed must be saved to allow the door swing to be reversed. 1. Carefully use a sharp tool to pry up the decorative cap at the top of the cabinet and also the cap of the door hinge (Fig.1). 2. Open the door slightly, remove the screw holding the door hinge cover, remove the upper door hinge cover, then unscrew all the screws holding the upper door hinge. Be sure to hold the glass door firmly while removing the screws and taking off the door (Fig. 2). 3.
OPERATING YOUR WINE COOLER The wine cooler should be placed where the ambient temperature is between 61 and 95 degrees Fahrenheit (16-35°C). If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate.
● LIGHT Button: This controls the LED cabinet light. NOTE: Once the light is turned on, it will shut off automatically after 10 minutes. ● °C/°F Button: Converts the temperature display to Celsius or Fahrenheit. ● ON/OFF Button: This turns the unit on or off. Press once to start the unit; press again to turn it off. To view the SET temperature for either chamber at any time, press SET button once.
To remove or change the position of a shelf Follow the illustrations and instructions below if you wish to take out a shelf: First remove all wine bottles from the shelf and pull it out as far as you can. Simultaneously press down the left lever on the sliding shelf and press the right one up, pulling the shelf out at the same time. Next, push up on the shelf to release the front hook from the shelf bracket. Then just pull the shelf out. To reinstall a shelf, follow these steps in reverse.
CARE AND MAINTENANCE Cleaning Your Wine Cooler 1. Turn off the power, unplug the appliance, and remove all items including shelves and racks. 2. Wash the inside surfaces with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. 3. Wash the shelves with a mild detergent solution. 4. Wring excess water out of the sponge or cloth when cleaning the area near the controls, or any electrical parts. 5.
PROBLEMS WITH YOUR WINE COOLER You can solve many common wine cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling a service technician. TROUBLESHOOTING GUIDE Problem Wine cooler does not operate. Possible Cause Not plugged in. The appliance is turned off. The circuit breaker has tripped or a fuse has blown. Wine cooler is not Check the temperature control setting. External cold enough.
NOTES 13
NOTES 14
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.