User's Manual

Summit User’s Guide – SDC-SSD40L

SDC-SSD40L_UsersGuide

Note: Although these values may vary with the properties of your host interface and the PCB, they are a

reasonable starting point.

Note: The series resistors in the SDIO bus provide several design benefits:

- If a host controller has too high of a drive strength, then bus ringing may result. Series resistors

can reduce this ringing on the I/O lines.

- Adding 27-56 ohms of series resistance on the SDIO bus will reduce sharp transitional edges,

which may reduce EMI.

- Having the series resistors in the PCB layout allows for design flexibility; If they are later found to

be unnecessary, zero (0) ohm jumpers may be used in their place

The following are also recommended:

 47 K ohm pull-ups on the CMD line and four data lines: SDIO_CMD, SDIO_DATA_0, SDIO_DATA_1,

SDIO_DATA_2, SDIO_DATA_3

Note: No pull-up is required on the CLK line.

Note: Make sure to apply the proper voltage on the VDDIO input to the SiP to match the signaling

voltage of the SDIO host interface (1.8V or 3.3V typically, but it can be anything in between these

values).