User's Manual

SUMMITSEMICONDUCTORLLC

22867NWBennettStreet,Suite200
Hillsboro,OR97124USA
Phone:5036157700Fax:5036154232
http://www.summitsemi.com

2.10FCCInterimSolutiontoDFSbandinterferencewithWeather
Radar
The grantee must ensure that the applications subject to this interim procedure must include
appropriate attestations that the device is intended for indoor use (through a clear indication in a
manual or labels with the device) and must demonstrate through test reports that the transmission is
disabled in the 5600 - 5650 MHz band.
Per above, the master device is intended for indoor use only.
The master device firmware is written to prevent usage of channel 120, 124, and 128 (5600, 5620,
5640).
3 OEMInstallationInstructions
In order to maintain compliance with FCC, Industry Canada, and any other applicable regulations, it
is required of the OEM or module level customer to adhere to the guidelines listed in this manual.
3.1 Flexcableinterface
The installation is approved for use with 4” to 12” length 40-pin 1.00mm(0.039”) pitch flat flex
cable.
3.2 Mountinghardware
The master device PC board provides four 3.5mm diameter holes intended to house up to 3mm
diameter mounting hardware. The installation does not require metal mounting standoff hardware
for grounding purposes but that is recommended.
3.3 Antennas
Antennas shall be mounted/separated at least 5 inches apart for proper operation of the device.
Antennas shall employ a permanent mounting style such that they are not readily changeable by the
customer.
Approved antennas:
Picture
Design
Frequency
Antenna
Gain
Gain
Method Type
Aeon Technology
C6276-510001A
2.4,5.8
GHz
2.2dBi Measured
1/4wave
dipole