User's Manual
Table Of Contents
SUMMITSEMICONDUCTORLLC
22867NWBennettStreet,Suite200
Hillsboro,OR97124USA
Phone:503615‐7700•Fax:503615‐4232
http://www.summitsemi.com
2 UserManualRegulatoryStatements
The United States Federal Communication Commission has established certain rules governing the
use of electronic equipment, including the following required guidelines.
2.1 FCC/ICIdentificationNumbers
UnitedStates FCCID:UA9600
IndustryCanada IC:9129A‐600
2.2 FCC/ICComplianceStatement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION:ANYCHANGESORMODIFICATIONSNOTEXPRESSLY
APPROVEDBYTHEPARTYRESPONSIBLEFORCOMPLIANCECOULDVOID
THEUSER’SAUTHORITYTOOPERATETHEEQUIPMENT.
2.3 FCCChangesWarning
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
2.4 FCC/ICInformationtotheuser
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment can generate and
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.