User's Manual
Table Of Contents
SUMMITSEMICONDUCTORLLC
22867NWBennettStreet,Suite200
Hillsboro,OR97124USA
Phone:503615‐7700•Fax:503615‐4232
http://www.summitsemi.com
—Consult the dealer or an experienced radio/TV technician for help.
Users should also be cautioned to take note that high-power radars are allocated as primary users
(meaning they have priority) of the bands 5250-5350 MHz, 5500-5700 MHz, and these radars could
cause interference and/or damage to WLAN devices.
2.5 FCCLabeling
While the FCC user ID is placed on the slave device circuit board, compliant labeling shall also be
placed on the end product housing exterior.
2.6 FCC/ICAntennausage
Antennas are required to be permanently attached or of non-standard connection method to prevent
the end user from altering the installation’s performance. The installer shall be responsible for this.
.
CAUTION:DONOTTRYTOREPLACETHEANTENNAS
2.7 MobileExposure
The user is cautioned to maintain 20cm (8 inch) spacing from the product to ensure compliance with
FCC requirements.
2.8 FCCModularapprovalconfigurationcontrol
Control of the end product into which the module will be installed must be maintained such that full
compliance of the end product is always ensured. The modular transmitter must comply with any
specific rule or operating requirements applicable to the transmitter and the manufacturer must
provide adequate instructions along with the module to explain any such requirements.
It is the responsibility of the OEM or module level customer to install the slave device in accordance
with the guidelines of this manual. In order to maintain compliance with FCC regulations, the
module installer must adhere to the guidelines listed in the installation section of this manual.
2.9 FCC/ICIndoorUsage
The device (for the band 5150-5250 MHz,) is only for indoor usage to reduce potential for harmful
interference to co-channel mobile satellite systems.