User's Manual

SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT MODULE – ATHENA 4XD
7 of 10
Model No. 444-2253 20575 NW Von Neumann Dr., Suite 100
www.summitsemi.com Beaverton, OR 97006 USA
TEL [phone]
FAX: [phone]
© 2015 Summit Semiconductor LLC
FCC / IC Changes Warning
CAUTION: ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED
BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER’S
AUTHORITY TO OPERATE THE EQUIPMENT.
ATTENTION: LES CHANGEMENTS OU MODIFICATIONS NON EXPRESSEMENT
APPROUVER PAR LA PARTIE RESPONSABLE DE LA CONFORMITÉ
POURRAIEMENT ANNULER L’AUTORITÉ DE L'UTILISATEUR DE L'APPAREIL
FCC Information to the user
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Users should also be cautioned to take note that high-power radars are allocated as
primary users (meaning they have priority) of the bands 5250-5350 MHz, 5600-5650
MHz, and 5650-5850 MHz and these radars could cause interference and/or damage to
WLAN devices.