User's Manual

SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT MODULE – ATHENA 4XD
8 of 10
Model No. 444-2253 20575 NW Von Neumann Dr., Suite 100
www.summitsemi.com Beaverton, OR 97006 USA
TEL [phone]
FAX: [phone]
© 2015 Summit Semiconductor LLC
IC Information to the User
Per RSS-Gen Section 3.2.1: The host device shall be properly labeled to identify the
modules within the host device. The Industry Canada certification label of a module shall
be clearly visible at all times when installed in the host device, otherwise the host device
must be labeled to display the Industry Canada certification number of the module,
preceded by the words “Contains transmitter module”, or the word “Contains”, or similar
wording expressing the same meaning, as follows: Contains transmitter module IC:
9129A-605
FCC Labeling
While the FCC user ID is placed on the master device circuit board, compliant labeling
shall also be placed on the end product housing exterior.
FCC / IC Antenna usage
Antennas are required to be permanently attached or of non-standard connection method
to prevent the end user from altering the installation’s performance. The installer shall be
responsible for this. The antennae are built-in. No change is provided for or allowed by
FCC/IC regulations.
.
CAUTION: DO NOT REPLACE THE ANTENNAS
ATTENTION : N'ESSAYEZ PAS DE REMPLACER LES ANTENNES
Mobile Exposure
The user is cautioned to maintain 10mm (0.39 inch) spacing from the product to ensure
compliance with FCC/IC requirements.