User's Manual

SUMMIT SEMICONDUCTOR LLC AUDIO WIRELESS CLIENT MODULE – ATHENA 4XD
9 of 10
Model No. 444-2253 20575 NW Von Neumann Dr., Suite 100
www.summitsemi.com Beaverton, OR 97006 USA
TEL [phone]
FAX: [phone]
© 2015 Summit Semiconductor LLC
FCC Modular approval configuration control
Control of the end product into which the module will be installed must be maintained
such that full compliance of the end product is always ensured. The modular transmitter
must comply with any specific rule or operating requirements applicable to the
transmitter and the manufacturer must provide adequate instructions along with the
module to explain any such requirements.
It is the responsibility of the OEM or module level customer to install the master device
in accordance with the guidelines of this manual. In order to maintain compliance with
FCC regulations, the module installer must adhere to the guidelines listed in the
installation section of this manual.
FCC / IC Indoor Usage
Operation of the radio in the 5150-5250 MHz frequency band is restricted to indoor use
only. The device (for the UNII-1 band and per interim weather radar interference) is only
for indoor usage to reduce potential for harmful interference to co-channel mobile
satellite systems.
EM Installation Instructions
In order to maintain compliance with FCC, Industry Canada, and any other applicable
regulations, it is required of the OEM or module level customer to adhere to the
guidelines listed in this manual.
Mounting hardware
The client device PC board provides two 3.5mm diameter holes intended to house up to
3mm diameter mounting hardware. The installation does not require metal mounting
standoff hardware for grounding purposes but that is recommended. There are three
guide pin holes adjacent to antennas A1, A2 and A3. Non-metallic pins should be used in
these holes.