PLUS 2/PRO/MED/GENERAL PURPOSE Refrigerators and Freezers for General Purpose Storage User Manual FELIX STORCH, INC. ISO 9001:2015 Registered 770 Garrison Avenue Bronx, New York10474 www.accucold.
MODEL NUMBERS PLUS 2 MODELS FF6L / FF7L / FF28LWH / FF511L / FF521BL / FFAR24L / SCR600L / FF590SSHH / FFAR10 / FFAR12W / FFAR121SS / PLUS2 Series All-refrigerators with automatic defrost or frost-free operation ACF48W / VT65ML / FS603 / FS407L / FS30L / FS24L PLUS2 Series All-freezers CM411L / CP351/ CT66L / S19LWH / CP133 PLUS2 Series Refrigerator-Freezers SP6DS / SP6DSSTB / SP6DS2D PLUS2 Series Drawer refrigerators PLUS2 all-refrigerators include digital thermostats, internal fans, and NIST calibrated th
TABLE OF CONTENTS Appliance Safety Installation of your Appliance Appliance Care Temperature Selection and Monitoring Keypad Lock Operation of Specific Models Troubleshooting Limited Warranty 4 5-7 7-9 9-12 13 14-15 15 16 3
APPLIANCE SAFETY Your safety and the safety of others are very important to us. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. You can be seriously injured or even killed if you don’t follow instructions. Safety messages will tell you what the potential hazard is, how to reduce the chance of injury, and what can happen if the instructions are not followed.
INSTALLATION OF YOUR APPLIANCE NOTE: Allow the appliance to sit upright for 24 hours before turning on to allow the compressor lubricant to drain. 1. Remove packaging materials. 2. Remove tape and glue residue from surfaces before turning on the appliance. Rub a small amount of liquid dish soap over the adhesive with your fingers. Rinse with warm water and dry. 3. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
NOTE: Do not install the appliance near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 40°F (5°C). Do not place in direct sunlight. Electrical Shock Hazzard: • Plug into a grounded 3-prong outlet. • Do not remove ground prong. • Do not use an adapter. • Do not use an extension cord. CAUTION: Failure to follow these instructions can result in fire, electrical shock or death.
turn on and off as needed to keep the appliance at the proper temperature. • For optimum temperature performance, it is recommended that this unit be at least 30% full during use. If you are only using this unit to store small loads, we recommend adding some water bottles or freezer packs to ensure temperature stability. • The outside of your appliance may feel warm. This is normal. The appliance’s design and main function is to remove heat from packages and air space inside the appliance.
5. To help with removing odors, you can use a mixture of warm water and baking soda (2 tbs to 1 qt of water) to wash the interior walls. 6. After cleaning, replace all of the parts that were removed from the appliance. 7. The condenser coils, located on the back or behind the base grille, should also be cleaned regularly. This may be as often as every other month. Cleaning the condenser coils can help reduce how much energy the appliance uses.
Maintenance of the Refrigerator or Freezer • Report breakdowns immediately and arrange for alternative monitored storage for vaccines while the appliance is being repaired. • Regularly check the door seals to ensure a good seal is maintained. Replace the seals if they are damaged or cold air is leaking from the appliance. • Defrost the appliance regularly, if required, to prevent build-up of ice which will result in unstable temperatures.
• In all small refrigerators and freezers without interior fans, temperatures are coldest near the bottom, and occasionally near the rear. Place contents accordingly. NOTE: For optimum temperature performance, it is recommended that your unit be at least 30% full during use. If you are only using this unit to store small loads, we recommend adding some water bottles or freezer packs to ensure temperature stability.
• The temperature display can be switched between Celsius (°C) and Fahrenheit (°F) with a push of the °C/°F button. The display will alternate between refrigerator (probe) temperature and room temperature when you press the ROOM/FRIDGE button. Press RESET to clear the Max/Min temperature record. Probe Hole/Access Port (PRO Series) PRO series refrigerators and freezers include a 3/8” probe hole to allow users to install their own monitoring equipment.
NOTE: A slight variation in temperature is often seen from one thermometer reading to another, even when the vaccine storage unit thermostat is set at a particular temperature. This is normal. If the thermometer reading does not fluctuate at all over several readings, temporarily remove the thermometer from the storage unit and place it outside the unit at room temperature. Check whether the temperature reading rises.
NOTE: For an activated high alarm and low alarm buzzer, the display should indicate HI-ALARM and LO-ALARM (see illustration on previous page). KEYPAD LOCK A keypad lock is optional on most models. Use the instructions below to use your keypad lock. Factory-set Default Password The factory-set default password is 0123.
OPERATION OF SPECIFIC MODELS FF6L, FF7L, FF28LWH, FF511L, FF521BL, FF590SSHH, FFAR24L, FFAR10, FFAR12W, FFAR121SS, SCR600L PLUS2, PRO, & MED Series; SP6DS2D, SP6DS, SP6DSSTB PLUS2 Series only; SCR610BL, SCR1156 MED Series only These models are all-refrigerators (no freezer compartment) with automatic defrost. All have cold plates on the rear wall, and the coldest spots in the refrigerator will be in the rear and toward the bottom. All have interior fans to promote even cooling.
are designed for built-in installation and need very little clearance on the sides and above the units. All other models require at least 4 inches of airflow on the sides and above the units. All models, including built-in units, operate best when 2 inches is provided between the rear wall and the back of the unit. TROUBLESHOOTING Try these solutions first to avoid the cost of an unnecessary service call. The appliance is not operating.
LIMITED WARRANTY ONE YEAR LIMITED WARRANTY FOR APPLIANCE Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factoryspecified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
