User Manual

11
Adjusting the Kick Plate
Only for models ASDR1524 / LADR1545 / ASDR1554 /
SDR1529 / LDR1549 / SDDR1558 / ASDR2414 /
LADR2433 / ASDR2444 / SDR2418 / LDR2437 and
SDDR2448.
The pre-fitted kick-plate of the appliance includes an
adjustable kick-plate section that is initially seated behind
the upper section. In order to adjust the kick-plate height,
follow the instructions below:
1. Remove the screws (1) from both the top left- and top
right-hand sides of the kick-plate.
2. Loosen or remove the screws (2) from both the bottom left- and bottom right-hand sides of the
kick-plate. Failure to loosen the bottom screws sufficiently may cause damage to the lower trim
when adjusting it.
3. Carefully guide the lower trim down until the desired height is achieved.
4. Reinsert screws and tighten them.
OPERATING YOUR APPLIANCE
It is recommended you install the appliance in a place where the ambient temperature is between
44º and 95ºF (7º to 35ºC). If the ambient temperature is above or below the recommended
temperatures, the performance of the unit may be affected. For example, placing your unit in
extremely cold or hot conditions may cause interior temperatures to fluctuate. The expected
operating temperature range may not be reached.
Control Panel for Refrigerators
(Only for refrigerators FF642D and SPR627OS2D)
ON/OFF Power
To turn the appliance off, press and hold the key for 5 seconds until the temperature display goes
off. To turn the appliance on, press and hold the key for 1 second until the temperature display
lights up.
NOTE: Pressing the POWER key once can switch off the audible alarm when the alarm is on.
UP +
Used to increase (warm) the set temperature by 1°C/1ºF.
1
2