Owner's Manual

10
Full Overlay Panel Installation
These models are designed for field-installed overlay panels. The overlay panels cover the stainless
steel to give a built-in appearance. The overlay panel
and appropriate hardware are not included with the
unit and the end user needs to prepare them himself.
Please follow the instructions below for installation:
• Remove any items stored inside the drawers.
Press the right slide release lever down and at the
same time lift the corresponding left slide lever up
and pull the drawer out until it is free of tracks and
the cabinet. (Fig. 1)
• Peel off the gasket and remove the handle by
removing the two screws that attach the handle to
the door.
• Drill the 2 holes shown by using a 3/16” drill bit on
the bottom of drawer door front. (Fig. 2)
• Cut the overlay panels with thickness 3/4” to the
following dimensions: 14.75” x 14.1” for models
ASDR1524 / LADR1545 / ASDR1554 / SDR1529 /
LDR1549 / SDDR1558; 23.43” x 14.1” for models
ASDR2414 / LADR2433 / ASDR2444 / SDR2418 /
LDR2437 / SDDR2448 / ADRD241 / FF642DADA
/ LDR24A / ADFD243 / SCFF532DADA / LDF24A
/ ADRF244 / SPRF2D24ADA /LDRF24A; 23.43” x
14.92” for models FF642D / SPR627OS2D /
SCFF532D / SPFF51OS2D / SPRF34D.
• If reusing the handles that came with the unit, drill
two holes with diameter 3/16” in the overlay panel.
Attach the handle and overlay panel together to
the drawer face using 2 M4x65 screws and
through the upper 2 existing holes inside the door
groove. Then attach the overlay panel to the
drawer face using 2 wood screws #10x2 (ST4x50)
Type AB Phillips and through the lower 2 existing
holes inside the door groove. (Fig. 3)
• If user-supplied handles will be used, attach the
handles to the overlay panels by using the flat
head screws and drive the screws flush with the panels. Then attach the overlay panel to the
drawer face using the 4 wood screws #10x2 (ST4x50) and through the 4 existing holes inside
the door groove.
• Peel back the gaskets, then align the left and right slide channels with the tracks in the cabinet.
Ensuring an even track engagement on both sides, gently push the drawer into the cabinet until
it stops.