Owner Manual

12
SABBATH MODE
Sabbath mode is available for the observance of certain religious holidays. This mode turns off the
displays, interior light and audible alarms and prevents them from turning on again. Normal cooling
operations will still take place.
To initiate Sabbath mode, touch the POWER and LIGHT keys at the same time for at least 5 seconds.
The indicator light will flash four times and confirm the Sabbath mode is ON.
Sabbath mode can be turned off by repeating the above process. The Sabbath mode will automatically
turn off after 96 hours.
TEMPERATURE MEMORY FUNCTION
In the event of a power interruption (power surge, breaker switch, etc.), the unit will remember the
previous temperature settings, and when the power is recovered, the cabinet temperature will return to
the same setting temperature as before power was lost.
TEMPERATURE ALARM / DOOR ALARM
An audible alarm sounds if the storage temperature is not cold enough. The temperature display
flashes at the same time.
The cause of the temperature being too high may be:
- Warm items were placed inside
- Too much warm ambient air flowed in when rearranging and removing contents
- Power failure for some time
- The appliance is faulty.
The audible alarm is automatically silenced and the temperature display stops flashing when the
temperature is sufficiently cold again.
If the door has been left open for more than 60 seconds, the alarm will sound. Touching the POWER
key once will switch off the audible alarm.
DOOR LOCK
Your unit is provided with a lock and key combination.
The keys are located inside the plastic bag that contains the Instruction Manual. Insert the key into the
lock and turn it counterclockwise to unlock the door. To lock the door, do the reverse operation, making
sure the metal pin is engaged completely. Remove the key and put it in a secure place.
SHELVES
To prevent damaging the door gasket, make sure to have the door all the way open when pulling the
shelves out of the rail compartment.
For easy access to the stored contents, you can pull the
shelf approximately halfway out of the rail compartment.
However this unit was designed with a plastic post on each
side of the shelf track to prevent shelf contents from falling.
When removing the shelf from the inner rails, make sure to
remove all shelf contents first. Then move the shelf to the
position where the notches in the shelf are exactly aligned
with the plastic posts and lift the shelf. In order to replace
the shelf, repeat this procedure in reverse.