WINE / BEVERAGE CENTER Model No.: ALFD24WBV Instruction Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS. Write Serial Number (on lower left corner of inside cabinet) here: Serial No.: _______________________ Felix Storch, Inc. An ISO 9001:2015 registered company 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
TABLE OF CONTENTS Appliance Safety 3 Important Safeguards 3-4 Location of Parts 5 Installation Instructions 6-7 Before Using Your Appliance 6 Installation of Your Appliance 6 Electrical Connection 6-7 Extension Cord 7 Adjusting the Height of the Unit 7 Adjusting the Kick-plate 7 Installing the Stainless Steel Handles 7 Operating Your Appliance 8-11 Recommended Temperature Settings 8 Control Panel 8-9 Interior Light 9 Sabbath Mode 9 Temperature Memory Function 10 Temperature
APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words DANGER or WARNING.
In the event of any damage: - Avoid open flames and anything that creates a spark, - Disconnect from the electrical power line, - Air the room in which the appliance islocated for several minutes, and - Contact the Service Department foradvice. The more coolant there is in an appliance, the larger the room it should be installed in. In the event of a leakage, if the appliance is in a small room, there is the danger of combustible gases building up.
LOCATION OF PARTS LED Light Digital Control Panel Handle LED Light Left Zone (Beverage Center) Right Zone (Wine Chiller) Glass Shelves(3) Wood Shelves(5) Glass Door Lock Adjustable Legs Kick-plate 5
INSTALLATION INSTRUCTIONS BEFORE USING YOUR APPLIANCE Remove the exterior and interior packing. CAUTION: After unpacking you MUST allow this appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so may adversely affect performance and the lifetime of the unit. Clean the interior surface with lukewarm water using a soft cloth. Install the handles on the doors. (See page 7.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded 3-prong wall outlet. To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or dangling. The appliance should always be plugged into its own individual electrical outlet that has a voltage rating that matches the rating label on the appliance.
OPERATING YOUR APPLIANCE It is recommended you install the appliance in a place where the ambient temperature is between 72º and 78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate. The desired temperature range may not be reached.
Setting the Temperature Control The unit has two separate temperature zones. The temperature of the left zone can be set between 36ºF and 43ºF (2ºC and 6ºC) which is suitable for storing beverages and the temperature of the right zone can be set between 41ºF and 68ºF (5ºC and 20ºC) which is suitable for storing wines. When the unit is plugged in for the first time, the unit will power up automatically to the preset defaults.
TEMPERATURE MEMORY FUNCTION In the event of a power interruption (power surge, breaker switch, etc.), the unit will remember the previous temperature settings, and when the power is recovered, the cabinet temperature will return to the same setting as before the power went off. TEMPERATURE ALARM / DOOR ALARM The audible alarm sounds if the storage temperature is not cold enough.The temperature display flashes at the same time.
- Keep small gaps between the walls and the bottles to allow air to circulate. As in an underground cellar, air circulation is important to prevent mold and for a more homogeneous temperature within the cellar. - To facilitate air circulation, do not overload your wine cellar. - Avoid obstructing the internal fans (located inside on the rear panel of the wine cellar). - To prevent bottles from falling, do not try to slide the shelves outward beyond the fixed position.
CARE AND MAINTENANCE CLEANING YOUR APPLIANCE Turn off the power, unplug the appliance, and remove all items, including shelves. Wash the inside surfaces with a solution of warm water and baking soda (about 2 tablespoons of baking soda to a quart of water). Wash wire shelves with a mild detergent solution. Wipe wooden shelves with a clean, damp cloth. Dry thoroughly. Wring excess water out of the sponge or cloth when cleaning the area where the controls are located, or any electrical parts.
TROUBLESHOOTING You can solve many common appliance problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. Troubleshooting Guide PROBLEM Appliance does not operate. POSSIBLE CAUSE Appliance is not connected to a power supply. The appliance is turned off. Tripped circuit breaker or blown fuse. The temperature is not set correctly. The ambient temperature could require a lower temperature setting.
The doors will not close properly. Display “E0”, “E1”. “E2”, “E3”, “E4”, “E5” or “E7”. The alarm sounds and the temperature display flashes. The icon “--” is lit up and flashing in the temperature display. The appliance is not properly leveled. The gaskets are dirty. The shelves are out of position. “E0” indicates a communication error for 3-zone models. “E1” or “E2” indicates that the air temperature sensor has failed.
NOTES 15
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.