Use & Care

8
Adjusting the Kick Plate
This appliance includes an adjustable kick-plate extender that is not
required to operate the unit. In order to adjust the kick-plate height,
follow the instructions below:
1. Remove the screws (2) from both the bottom left- and bottom
right-hand sides of the kick-plate installed on the unit.
2. Loosen the screws (1) from both the top left- and top right-hand
sides of the kick-plate installed on the unit.
3. Carefully insert the kick-plate extender under the kick-plate until
the desired height is achieved.
4. Reinsert screws and tighten them.
Installing the Stainless Steel Handles
This appliance includes two stainless steel handle that are not
required to operate the unit. To install each handle, follow the
instructions below:
1. Remove the door gasket (2) on the side you wish to install
the handle - you can see two designated holes for
handle installation.
2. Install the handle (4) tightly as shown here with two screws (1)
and flat washers (3) provided.
3. Replace the door gasket.