Owner's Manual
Table Of Contents
- IMPORTANT SAFEGUARDS
- /Before the ice maker is used, it must be properly positioned and installed as described in this manual, so read the manual carefully. SUMMIT® APPLIANCE strongly recommends that you have a professional install your new machine. The warranty may be aff...
- SAVE THESE INSTRUCTIONS
- Electrical Connection
- Extension Cord
- Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this ice maker.
- TECHNICAL INFORMATION
- Excessive Weight Hazard
- Electrical Shock Hazard
- You must connect the drain line before using the ice maker. Follow the steps below.
- Connecting the drain line:
- Mobile installation:
- Enclosed Installation:
- Operating Method
- Set the ON/OFF button to the ON position. The machine will automatically go to the ice making stage.
- There are two distinct cycles: ice freeze and harvest.
- Preparing the Ice Maker for Long Storage
- Exterior cleaning
- MAJOR FUNCTIONS
- IMPORTANT SAFEGUARDS
- /Avant la machine à glaçons est utilisée, elle doit être correctement positionnée et installée comme décrit dans ce manuel, donc lire attentivement le manuel. SUMMIT® APPLIANCE recommande fortement que vous avez un professionnel installer votre nouvel...
- CONSERVEZ CES INSTRUCTIONS
- Connexion électrique
- Rallonge
- En raison des risques potentiels pour la sécurité dans certaines conditions, il est fortement recommandé de ne pas utiliser une rallonge avec ce fabricant de glace.
- INFORMATIONS TECHNIQUES
- Vous devez connecter la ligne de vidange avant d'utiliser la machine à glaçons. Suivez les étapes ci-dessous.
- Installation mobile :
- Installation close :
- Méthode de fonctionnement
- Risque de choc électrique
- Réglez le bouton ON / OFF sur la position ON. La machine se met automatiquement à l'étape de fabrication de glace.
- Il y a deux cycles distincts: la congélation de la glace et la récolte.
22
2. Open the door and take out the removable ice storage bin. With a clean cloth, wipe
down the interior of unit and ice bin with a sanitizing solution made of 1 ounce of
household bleach or chlorine and 2 gallons of hot (95ºF – 115ºF) water.
3. Pull off the drain hose of the water trough to drain off all water.
4. Rinse thoroughly with clear water.
5. After draining off all water, put back the drain hose of the water
trough into the original location.
6. Put the ice storage bin inside the unit.
7. Reconnect power to the unit.
The ice scoop should be washed regularly. Wash it just like any
other food container.
Condenser cleaning
A dirty or clogged condenser prevents proper airflow, reduces ice making capacity, and
causes higher than recommended operating temperatures that may lead to component
failure. Have the condenser cleaned at least once every six months.
1. Unplug the ice maker or disconnect power.
2. Gently pull off the lower front louver.
3. Remove dirt and lint from the condenser and the
unit compartment with the brush attachment of a
vacuum cleaner
.
4. Reassemble the lower front louver.
5. Plug in the ice maker or reconnect power.
DO NOT use solvent-based cleaning agents or abrasives on the interior.
These cleaners may transmit taste to the ice cubes
and damage or
discolor the interior.
DO NOT touch the condenser.
Edges are sharp and can be easily damaged.
Condenser
Surface
Correct location of
the drain hose