Owner's Manual
Table Of Contents
- IMPORTANT SAFEGUARDS
- /Before the ice maker is used, it must be properly positioned and installed as described in this manual, so read the manual carefully. SUMMIT® APPLIANCE strongly recommends that you have a professional install your new machine. The warranty may be aff...
- SAVE THESE INSTRUCTIONS
- Electrical Connection
- Extension Cord
- Because of potential safety hazards under certain conditions, it is strongly recommended that you do not use an extension cord with this ice maker.
- TECHNICAL INFORMATION
- Excessive Weight Hazard
- Electrical Shock Hazard
- You must connect the drain line before using the ice maker. Follow the steps below.
- Connecting the drain line:
- Mobile installation:
- Enclosed Installation:
- Operating Method
- Set the ON/OFF button to the ON position. The machine will automatically go to the ice making stage.
- There are two distinct cycles: ice freeze and harvest.
- Preparing the Ice Maker for Long Storage
- Exterior cleaning
- MAJOR FUNCTIONS
- IMPORTANT SAFEGUARDS
- /Avant la machine à glaçons est utilisée, elle doit être correctement positionnée et installée comme décrit dans ce manuel, donc lire attentivement le manuel. SUMMIT® APPLIANCE recommande fortement que vous avez un professionnel installer votre nouvel...
- CONSERVEZ CES INSTRUCTIONS
- Connexion électrique
- Rallonge
- En raison des risques potentiels pour la sécurité dans certaines conditions, il est fortement recommandé de ne pas utiliser une rallonge avec ce fabricant de glace.
- INFORMATIONS TECHNIQUES
- Vous devez connecter la ligne de vidange avant d'utiliser la machine à glaçons. Suivez les étapes ci-dessous.
- Installation mobile :
- Installation close :
- Méthode de fonctionnement
- Risque de choc électrique
- Réglez le bouton ON / OFF sur la position ON. La machine se met automatiquement à l'étape de fabrication de glace.
- Il y a deux cycles distincts: la congélation de la glace et la récolte.
42
Drenaje
Usted debe conectar la línea de drenaje antes de usar al fabricante de hielo. Hay dos
tipos de modos del fabricante de hielo, uno que drena por gravedad y uno que tiene una
bomba de drenaje interno.
Esta unidad puede bombear el agua hasta un aumento de 1,5 m (59 ")
o sobre una longitud horizontal de 1,5 m (59").
Siga los pasos resumidos en la siguiente página.
VÁLVULA
DE AGUA
DRENAJE DE AGUA
ENTRADA DE AGUA
POTENCIA
FILTRO
DE AGUA
VÁLVULA
DE AGUA
FILTRO
DE AGUA
DRENAJE DE AGUA
ENTRADA DE AGUA
POTENCIA
NOTA:
La salida de la manguera de
desagüe debe ser elevada más
alto que la superficie del agua
con el fin de evitar que el agua
drenada fluye de nuevo en el
depósito d’agua.