Use and Care

Anti-Tip Bracket Installation

To reduce the risk of tipping the unit by abnormal usage or improper loading, the appliance must be

secured by properly installing the anti-tip device packed with the appliance.

• Place the anti-tip bracket on the floor as shown in the figure. An anti-tip bracket must be installed

at the left side.

• Mark the locations of the 4 holes of the anti-tip bracket on the floor.

• Use a 5/16” masonry drill bit and insert plastic anchors.

• Secure bracket to floor using screws.

• Slide appliance into position and make sure the leg engages the anti-tip bracket.

NOTE: If the unit is relocated, the bracket must be removed and installed in the new location.

Installing the Stainless Steel Handle

This appliance includes a stainless steel handle that is not required

to operate the unit. To install the handle, follow the instructions

below:

Locate the handle (1) over the mounting stub (3) of the door

and using the supplied Allen key, tighten the securing grub screws

(2) to fix the handle.