WINE CELLARS Model Nos.: CL155WC / CL185WC / CL244WC Instruction Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS.
TABLE OF CONTENTS Appliance Safety Important Safeguards Disposal Location of Parts Installation Instructions Before Using your Appliance Installation of your Appliance Electrical Connection Anti-Tip Bracket Installation Installing the Stainless Steel Handle Operating Instructions Recommended Temperature Settings Control Panel for Models CL155WC and CL185WC Control Panel for Model CL244WC Interior Light Sabbath Mode Temperature Memory Function Temperature Alarm/Door Alarm Wine Shelves Defrosting Storage Care
APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words "DANGER" or "WARNING".
• In the event of any damage: - Avoid open flames and anything that creates a spark, - Disconnect from the electrical power line, - Air the room in which the appliance is located for several minutes and - Contact the Service Department for advice. • The more coolant there is in an appliance, the larger the room it should be installed in. In the event of a leakage, if the appliance is in a small room, there is the danger of combustible gases building up.
Risk of child entrapment! Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are still dangerous, even if they will “just sit in the garage a few days”. Before discarding your old refrigerator: • Take off the doors • Leave the shelves in place so that children may not easily climb inside. - SAVE THESE INSTRUCTIONS - DISPOSAL Dispose of your appliance packaging properly. Ensure that any plastic wrappings, bags, etc.
LOCATION OF PARTS Model CL155WC Model CL185WC 6
Model CL244WC 7
INSTALLATION INSTRUCTIONS Before Using your Appliance • Remove the exterior and interior packing. • Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • Clean the interior surface with lukewarm water using a soft cloth. • Install the handle on the door. (See page 10.
Electrical Connection This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of electrical shock. Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For personal safety, this appliance must be properly grounded. This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet.
Anti-Tip Bracket Installation To reduce the risk of tipping the unit by abnormal usage or improper loading, the appliance must be secured by properly installing the anti-tip device packed with the appliance. • • • • • Place the anti-tip bracket on the floor as shown in the figure. An anti-tip bracket must be installed at the left side. Mark the locations of the 4 holes of the anti-tip bracket on the floor. Use a 5/16” masonry drill bit and insert plastic anchors. Secure bracket to floor using screws.
OPERATING YOUR APPLIANCE It is recommended that you install the appliance in a place where the ambient temperature is between 72º and 78ºF (23º–26ºC). If the ambient temperature is above or below the recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate. The range of 41º – 68ºF (5º – 20ºC) may not be reached.
Setting the Temperature Control • You can set the temperature by touching the UP and DOWN symbols. When you push the two buttons at the same time, the LED readout will show the original temperature set previously. (The temperature preset at the factory is 54°F, or 12°C.) • The temperature you are setting will increase by one degree each time you touch the Up symbol, and will decrease by one degree each time you touch the DOWN symbol. • The range of the temperature control is from 41°F to 68°F.
Setting the Temperature Control • The unit has two separate temperature zones. The temperature of both zones can be set between 41ºF and 68ºF (5ºC and 20ºC). It can be used as a wine maturing cabinet or a wine serving cabinet. For maturing wine, the recommended temperature setting ranges of both zones should be between 52ºF and 57ºF (11ºC and 14ºC).
Sabbath Mode • • • Sabbath mode is available for the observance of certain religious holidays. This mode turns off the displays, interior light and audible alarms and prevents them from turning on again. Normal cooling operations will still take place. To initiate Sabbath mode, press the POWER and LIGHT keys at the same time for at least 5 seconds. The indicator light will flash four times to confirm the Sabbath mode is ON. Sabbath mode can be canceled by repeating the above process.
Storage Bottles can differ in size. Accordingly, the actual number of bottles you can store may vary. The approximate maximum bottle capacity can be achieved when storing traditional 750 ml Bordeaux bottles in bulk storage. You may load your wine bottles in single rows or by stacking while taking note of the following: if you do not have enough bottles to fill your wine cellar, it is better to distribute the load throughout the wine cellar so as to avoid “all on top” or “all below” type loads.
Moving your Appliance 1. 2. 3. 4. 5. Remove all items. Securely tape down all loose items (shelves) inside your appliance. Turn the adjustable legs up to the base to avoid damage. Tape the door(s) shut. Be sure the appliance stays secure in the upright position during transportation. Also, protect the outside of the appliance with a blanket or similar item.
The light does not work. Vibrations The appliance seems to make too much noise. The door will not close properly. Display “E0”, “E1”. “E2”, “E3”, “E4”, “E5” or “E7”. The alarm sounds and the temperature display flashes. The icon “--” is lit up and flashing in the temperature display. • Appliance is not connected to a power supply. • Tripped circuit breaker or blown fuse. • The light was switched off on the control panel. • Connect the appliance. • The appliance is not properly leveled.
NOTES 18
NOTES 19
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.