Installation & Owners Manual

OPERATING INSTRUCTIONS

BEFORE USING THE COOKTOP

Before using the cooktop for the first time, clean it thoroughly with an approved ceramic

cooktop cleaner according to the Care and Cleaning instructions in this guide. This will help

protect the ceramic surface and make future cleanups easier.

CAUTION

Never use scrub pads or abrasive or etching cleansers. They can cause

permanent damage to the cooktop surface.

SETTING THE CONTROLS

To operate the touch control pads, touch the pad firmly with the flat part of your fingertip.

First operation

The first time that power is supplied to the cooktop, a beep will sound and all indicators and

the LED display will flash once. The ON/OFF light starts to flash. The Cooking Zone display

shows – indicating the appliance is connected to a power source. Press the ON/OFF pad

once, The ON/OFF light remains on, indicating that the appliance is in selection mode.

Press the corresponding Cooking Zone pad to start operation.

Activating the cooktop

To turn ON the cooktop, touch the POWER ON/OFF pad for approximately 2 seconds. The

indicator above the pad will light.

To turn OFF the cooktop, touch the POWER ON/OFF pad. The indicator light above the

pad will start to flash.

NOTE: After turning on the cooktop with the POWER ON/OFF pad, you must select

one of the Cooking Zones within 60 seconds using the Cooking Zone pad. If no

selection is made, the cooktop will turn off for safety.

Selecting the Cooking Zone and Power Level

To select the desired Cooking Zone, touch the

pad. The display for the selected Cooking Zone will show 5. Then press

to adjust the power level from 0 to 9.

To readjust the power level:

Select a Cooking Zone, then select the desired power level. If a new power level is not

selected after 5 seconds, the power level of the Cooking Zone will remain the same.

Hot Hot Hot Hot