Pub Cellar Manual

SCR600BLPUB series models

1. Unscrew the lower hinge and take off the door.

2. Push the kick plate to the right in the new position, being careful not to damage the

wires connected to the back of the digital thermostat.

3. Undo the upper hinge fastener and fix it to the opposite side of the housing, where you

have already removed and replaced the fastener with the hole to the opposite side.

4. Put the door on the upper hinge fastener.

5. Fix the lower hinge in the new position.

6. Unscrew the handle and place it on the opposite side.

7. Some screws are covered with caps. Take off these caps before undoing the screws.

8. Check the door gasket. It should not be creased and should seal well.

1. Upper hinge fastener 4. Handle

2. Lower hinge 5. Door hinge fixture

3. Kick plate 6. Door hinge fixture plug

Door Handle Installation:

For model series FF7LBLPUB, FF63BDTPUB and SCR600BLPUB, the door has two

screw holes on each side, allowing you to install a handle (included). To do so, align the

handle with the screw holes on the side you prefer. Fix the handle in place with the

included screws, then cover the screw heads with the handle seal (included).