Use and Care Manual

CLEANING

CAUTION: Always disconnect the appliance from the gas and electricity supplies before carrying out

any cleaning operation.

Continuous use can cause the burners to change color due to the high temperature. To properly clean

your appliance, follow these steps:

• Periodically wash the hot plate, the enameled steel pan support, the enameled burner caps “A”,

“B” and “C” and the burner heads "T" (see fig. 10 and 11) with lukewarm soapy water. Also clean

plugs "AC" and flame detection "TC" (see fig. 10). Clean them gently with a small nylon brush as

shown (see fig. 12) and allow to dry fully.

NOTE: Do not wash in the dishwasher. It is very important to clean the surface soon after every use,

while the glass is still somewhat warm.

• Do not allow vinegar, coffee, milk, salt water, or lemon or tomato juice to remain in contact with

the enameled surfaces for long periods of time.

• Do not clean using abrasive metal scourers, abrasive powders or corrosive sprays.

Before Remounting Parts

Comply with the following instructions, before remounting the parts:

• Check that burner head slots have not become clogged by foreign bodies.

• Check that enameled burner caps “A-B-C” (fig. 10-11) have been correctly positioned on the

burner head. They must be steady.

• The exact position of the pan support is established by the rounded corners, which should be set

towards the side edge of the hot plate.

• Do not force the taps if they are difficult to open or close. Contact customer service for technical

assistance or repairs.

• Correctly preserve the plate after use by treating it with special, easily available products. This

will keep the surface of the plate clean and bright. The operation will also prevent the formation

of rust.

• Don’t use steam jets to clean the equipment.

• Food burnt onto an electric plate must be removed dry.

• After use, pour a little lukewarm oil on the plate and wipe it with a cloth.

Fig. 10 Fig. 11 Fig. 12