Manualshelf

Use and Care Manual

ManualsBrandsSummit ManualsCooking Appliances30 Inch Gas Cooktop with 5 Sealed Burners, Continuous Cast Iron Grates, Stainless Steel Surface, Ultra Rapid Burner, Auxiliary Burner, Heavy-Duty Round Knobs, Thermocouple Flame Failure Protection, and Laser-Etched Graphics
11121314151617181920
19
SERVICING
Always disconnect the appliance from the electric and gas supplies before proceeding with any
servicing operation.
Replacing Components
• To replace the components housed inside the appliance, remove the trivets and the burners
from the upper part of the cooktop. Remove the fixing screws "V" of the burner (Fig. 13) and the
knobs using hand pressure to remove them from the appliance.
• After having carried out these operations, the burners (Fig. 14), taps (Fig. 15) and electrical
components can all be replaced (Fig. 16).
• It is advisable to change seal "D" (Fig. 15) whenever a tap is replaced to ensure a perfect
tightness.
Greasing the Taps
If a tap becomes stiff to operate, it must be greased immediately in compliance with the following
instructions:
1. Remove the tap.
2. Clean the cone and its
housing using a cloth
soaked in solvent.
3. Lightly grease the
cone.
4. Fit the cone back into
place, operate it a few
times and then remove
it again.
5. Eliminate any excess
grease and check that
the gas ducts have not
become clogged.
6. Fit all parts back into place, following the disassembly order in reverse.
7. The tight closure test must be done using a foaming liquid.
NOTE: Never use a flame for this test.