Manualshelf

Rear Wall Template

ManualsBrandsSummit ManualsCooking Appliances24 Inch Over-the-Range Microwave with 1.4 Cu. Ft. Capacity, 10 Power Levels, Range Hood Function, Under Cabinet Lighting, Window, Eco Mode, Multi-stage Cooking, and Glass Turntable: Black
1
609.6（24"）
12"
4"
K.CUT OUT FOR HORIZONTAL
OUTSIDE EXHAUST
3/8" TO EDGE
24" MINIMUM WIDTH REQUIRED
REAR WALL TEMPLATE
CAUTION -IF EXHAUST ADAPTOR IS POSITIONED OUTSIDE
RECOMMENDED DIMENSION，GREASE-LADEN AIR WILL
DISCHARGE INTO HOUSE STRUCTURE.
CUT HOLE THROUGH REAR WALL FOR EXHAUST ADAPTOR
NOTE:IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This Rear Wall Template serves to position the bottom
mounting plate and to locate the horizontal exhaust outlet.
1.Use a level to check that the template is positioned
accurately.
2.Locate and mark at least one stud on the left or right side
of the centerline.
3.Drill holes in the marked locations.Drill a 3/16"
hole for wood screw and 5/8" holes for toggle bolts.
NOTE: Do NOT INSTALL THE MOUNTING PLATE AT THIS
TIME.
4.Remove the tempalte from the rear wall.
5.Review the Installation Instruction book for your
installation situation.
Locate and mark holes to align with holes in the
mounting plate.
IMPROTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTERLINE.
MARK THE LOCATION FOR 2 ADDITIONAL, EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
Trim the rear wall template along the dotted line.
A
C
B
6"
435（17 1/8"）

Summary of content (1 pages)