BUILT-IN UNDERCOUNTER COMMERCIAL DUAL-TAP BEER DISPENSERS (KEGERATORS) Solid Door Models: SBC58BLBIADA SBC58BLCSSADA SBC58BLBIIFADA Glass Door Models: SBC56GBIADA SBC56GBICSSADA SBC56GWBIADA Instruction Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS NOTE: These units are designed for the cooling and dispensing of beer only, and are not recommended for storing perishable foods such as meats or dairy products.
IMPORTANT SAFEGUARDS Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words DANGER or WARNING.
recommended in this material. All other servicing should be referred to a qualified technician. DANGER – RISK OF FIRE OR EXPLOSION. FLAMMABLE RFRIGERANT USED. TO BE REPAIRED BY TRAINED SERVICE PERSONNEL. DO NOT PUNCTURE REFRIGERANT TUBING.
These appliances are CFC- and HFC-free and contain a small quantity of Isobutane (R600a) which is environmentally friendly, but flammable. It does not damage the ozone layer, nor does it increase the greenhouse effect. Care must be taken during transportation and setting up of the appliance that no parts of the cooling system are damaged. Leaking coolant can ignite and may damage the eyes.
• Never allow children to operate, play with, or crawl inside the refrigerator/freezer. THIS APPLIANCE IS NOT INTENDED FOR USE BY YOUNG CHILDREN OR INFIRM PERSONS UNLESS THEY HAVE BEEN ADEQUATELY SUPERVISED BY A RESPONSIBLE PERSON TO ENSURE THAT THEY CAN USE THE APPLIANCE SAFELY. YOUNG CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH THE APPLIANCE.
Table of Contents Important Safeguards ............................................................................................... 1 - 2 Location of Parts ............................................................................................................ 4 Technical Information .................................................................................................... 5 Installation Instructions .........................................................................................
Location of Parts Models SBC58BL and SBC58W Series Twin taps Railing Temperature control dial (thermostat) and interior light CO2 canister holder Stainless steel door Front ventilation slots (kick plate) Compressor step Leveling legs Models SBC56G and SBC56GW Series Twin taps Railing Temperature control dial (thermostat), light switch and interior light Lock Glass door Handle CO2 canister holder Front ventilation slots (kick plate) Compressor step Leveling legs 6
Technical Information Model Numbers and Descriptions SBC58BLBIADA (reversible stainless steel door with horizontal handle, black cabinet) SBC58BLCSSADA (stainless steel cabinet and door [factoryreversible only], SS towel bar handle) SBC58BLBIIFADA (panel-ready door, factory-reversible only; handle provided by customer) SBC56GBIADA (reversible glass door, black cabinet) SBC56GBICSSADA (stainless steel-wrapped cabinet, SS towel bar handle, factory-reversible door only) Capacity Two 1/6 kegs Electrical In
Installation Instructions Parts List Remove all packing materials and parts. Inspect to make sure all parts listed below are present and in good condition: 1 double draft arm assembly (with washer) 1 CO2 cylinder 1 CO2 regulator 2 keg taps (American Sankey type) 1 cleaning kit Vinyl tubing 1 stainless steel (removable) floor to protect the unit during keg insertion 1 drip tray Hose clamps Various screws Before Using Your Appliance: • • Remove the exterior and interior packing.
Electrical Connection: Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. This unit should be properly grounded for your safety. The power cord of this unit is equipped with a three-prong plug which mates with a standard three-prong wall outlet to minimize the possibility of electrical shock.
Reversing the Door Swing If you find the direction of opening the door for either of the model series SBC58BL or SBC56G (excluding “CSS” and “IF” models) inconvenient, you can change it. Holes on the opposite side have already been prepared at the factory. This appliance can be opened from either the right side or the left. By default, the door hinge is on the right side. If you prefer it on the left, please follow the appropriate instructions: For SBC58BL models: 1.
For SBC56G models: NOTES: See illustration below. All of the parts that are removed must be kept for the reinstallation of the door. 1. Unscrew the lower hinge and take off the door. 2. Push the kick plate to the right in the new position. 3. Undo the upper hinge fastener and fix it to the opposite side of the housing, where you have already removed and replaced the fastener with the hole to the opposite side 4. Put the door on the upper hinge fastener. 5. Fix the lower hinge in the new position. 6.
Adjusting the Tilt If your beer cooler seems unsteady or you would like the door to close more easily, you can use the leveling legs to adjust the tilt of the unit. Be sure that the unit is in its final position when making adjustments to the tilt and that it is plugged into a grounded 3-prong outlet. WARNING: Two or more people are required to move and/or install the refrigerator. Failure to do so may cause back or other injury.
CO2 Regulator and CO2 Cylinder NOTE: Your CO2 cylinder is shipped empty to avoid any possible accidents during transportation. When you purchase the first keg of beer, have your beer distributor fill the CO2 cylinder. You must read and understand the following procedures for CO2 cylinders before installation: 1. Install the CO2 gas line tube to the regulator by attaching one end of the red tube to the hose connection on the CO2 regulator. 2.
d. Place the CO2 tank and CO2 regulator valve component into the cabinet and fix the CO 2 tank with tank bracket and retainer (See Figure 8). 3. Install the beer keg: Note: This unit can hold two one-sixth barrel kegs, but not a full-size keg. Place the beer keg into the cabinet and firmly connect the keg’s opening to the connection port of the mixed ball valve.
Operating Your Kegerator Temperature Control: • • • • • • Your appliance’s evaporator system is out of sight behind the interior rear wall. The interior temperature is controlled with a thermostat knob located inside the unit, towards the upper right-hand corner. Turn the knob clockwise from the STOP (0) position toward the higher numbers for colder temperatures. Higher settings on the knob (higher numbers) mean lower temperatures (colder) in the kegerator.
Care and Maintenance Cleaning Your Appliance: 1. Unplug the appliance, turn the thermostat to STOP (0) and remove all contents, 2. 3. 4. 5. 6. including shelves. Wash the inside surfaces with a solution of lukewarm water and vinegar. Wipe dry with a clean, soft cloth. Wash the outside cabinet with a solution of warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth.
Draft Beer Troubleshooting Problem Cause Correction Beer is cloudy: The beer in the glass appears hazy and not clear. Excessively low temperatures may cause hazy or cloudy beer, particularly when the beer lies in the cold coil for long periods of time. Drain a few ounces before drinking. Glasses may not have been cleaned properly. Do not wash beer glasses together with glasses that have contained milk or any other fatty substance.
Beer has off taste: Often bitter and bite-y; sometimes completely lacking flavor and zest. It may also have an oily or foul odor which may carry an unpleasant taste. Improper cleaning of the tap Brush and clean the tap properly. It should be scoured using a detergent, then rinsed clean. Contaminated air line Beer tube should be examined. If contaminated, it should be replaced. Condensation is forming on the tap. It is normal to see condensation forming on the tap.
General Troubleshooting When using this appliance, you may come across some problems that in many cases result from improper handling and can easily be eliminated. TROUBLESHOOTING GUIDE The appliance fails to operate after being connected to the power source. • Check whether the power supply is active and that the thermostat is not set to the STOP (0) position. The compressor is running continuously. • The door was opened frequently or it was left open too long.
Limited Warranty ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.