Manualshelf

Use & Care

ManualsBrandsSummit ManualsBeer Coolers & Kegerators24 Inch Built-in Beer Dispenser with 1 Half-Barrel Capacity, Digital Thermostat, Automatic Defrost, Single Tap Kit, Locking Casters and Top Guard Rail: Horizontal Handle Stainless Steel
12345678910
7
Instructions for Building-In
Locate the cutout hole
From left to right the width is about 24¼", so the midpoint is 12⅛“ from either side. Mark this
point along the rear edge and also along the front edge, then, with a pencil, draw a line
connecting these two points. Mark a point on this line 7⅞” from the rear, and this will be the
location of the drill hole.
:
Drill a round hole
Place a drill bit on the marked location and make a round hole with a diameter of 2⅝".
:
Installation
See Installation instructions in this manual.
: