FROST-FREE FREEZER Model: SCFF1842 Owner’s Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Write the Serial Number here: _______________________ Felix Storch, Inc. Summit Appliance Division An ISO 9001:2008 registered company 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
TABLE OF CONTENTS Important Safeguards ....................................................................................... 3 – 4 Technical Information ............................................................................................. 4 Installation Instructions .......................................................................................... 5 Before Using Your Freezer .................................................................................. 5 Installation of Your Freezer ..
IMPORTANT SAFEGUARDS Before the appliance is used, it must be properly positioned and installed as described in this manual, so read the manual carefully. To reduce the risk of fire, electrical shock or injury when using the appliance, follow basic precautions, including the following: Read all instructions before using the freezer. Plug into a grounded 3-prong outlet, do not remove grounding prong, do not use an adapter, and do not use an extension cord. Replace all panels before operating.
adjustments to level it. All installations must be in accordance with local plumbing code requirements. Make certain that the pipes are not pinched, kinked or damaged during installation. Check for leaks after connection. Never allow children to operate, play with or crawl inside the appliance. Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may damage or discolor the interior.
INSTALLATION INSTRUCTIONS Before Using Your Freezer 1. Remove the exterior and interior packing. 2. CAUTION: After unpacking you MUST allow this appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so may adversely affect performance and the lifetime of this unit. 3. Clean the interior surface with lukewarm water using a soft cloth. 4. Install the handle on the left side of the door.
OPERATING YOUR FREEZER Control Panel The freezer should be placed where the ambient temperature is between 61 and 90°F (16 to 32°C). If the ambient temperature is above or below this range, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperature to fluctuate. Control panel ON/OFF Power To turn the appliance on or off, press the ON/OFF button.
“Fast Freeze” Function If you press and hold the °C/°F button for 3 seconds, the unit will enter the “Fast Freeze” mode. In this mode, press the and buttons to set the fast freezing time. The setting time range is 1 to 10 hours, and the default setting time is 3 hours. If you set the fast freezing time longer than 4 hours, the unit will defrost itself at the end of the “Fast Freeze” cycle. To stop the “Fast Freeze” function, again press the °C/°F button and hold it for at least 3 seconds.
CARE AND MAINTENANCE Cleaning Your Freezer Turn off the power, unplug the appliance, and remove all items including shelves and racks. Wash the inside surfaces with a warm water and baking soda solution. Prepare the solution by mixing about 2 tablespoons of baking soda with a quart of water. Wash the shelves with a mild detergent solution. Wring excess water out of the sponge or cloth when cleaning the area of the controls, or any electrical parts.
PROBLEMS WITH YOUR FREEZER You can solve many common freezer problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE Not plugged in. The appliance is turned off. The circuit breaker has tripped or a fuse has blown. Check the temperature control setting. External environment may require a higher setting. The door is opened too often.
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
