BEVERAGE MERCHANDISERS Model Nos.: SCR610BL / SCR1156 Instruction Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS. Write Serial No. (on lower left corner of inside cabinet) here: ____________________________________________ Felix Storch, Inc. 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
TABLE OF CONTENTS Appliance Safety 3 Important Safeguards 3-4 Location of Parts 5 Installation Instructions 6-8 Before Using Your Appliance 6 Installation of Your Appliance 6 Electrical Connection 6-7 Extension Cord 7 Reversing the Door Swing of Your Appliance Installing the Stainless Steel Handle Operating Your Appliance 7-8 8 8-10 Control Panel 8-9 Sabbath Mode 9 Temperature Memory Function 9 Temperature Alarm / Door Alarm 9-10 Door Lock 10 Defrosting 10 Care and Maintenance
APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words "DANGER" or "WARNING".
In the event of any damage: - Avoid open flames and anything that creates a spark, - Disconnect from the electrical power line, - Air the room in which the appliance is located for several minutes and - Contact the Service Department for advice. • The more coolant there is in an appliance, the larger the room it should be installed in. In the event of a leakage, if the appliance is in a small room, there is the danger of combustible gases building up.
LOCATION OF PARTS MODEL SCR610BL Door Shelves (3) Handle Security Lock Ventilation Grille Adjustable Legs Digital control panel Cabinet MODEL SCR1156 Door Shelves (4) Handle Security Lock Ventilation Grille Adjustable Legs Digital control panel Cabinet 5
INSTALLATION INSTRUCTIONS BEFORE USING YOUR APPLIANCE • Remove the exterior and interior packing. • Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. • Clean the interior surface with lukewarm water using a soft cloth. • Install the handle on the door. (See page 8.
replaced with a properly grounded 3-prong wall outlet. To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or dangling. The appliance should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating label on the appliance. This provides the best performance and also prevents overloading house wiring circuits that could cause a fire hazard from overheating.
5. Screw the alternative left top hinge 8, included in the fittings, on the left hand side of cabinet. (Fig. 3) 6. Relocate the door to the designated position. Then screw the bottom hinge assembly on the left designated position and tighten it after the door is leveled. (Fig. 1) 7. Remove the handle from the left side of the door and install it on the right side. (See next section.
Interior Light The interior light makes it easy to view your items. Touching the LIGHT symbol toggles between 2 modes of operation for the internal lights: functional (default) mode and showcase mode. If you are in functional (default) mode, the lights will turn on only when the door is open. If you are in showcase mode, the lights will be on whether or not the door is open. ºF/ºC Selector Select the temperature display in Fahrenheit or Celsius degrees.
• The cause of the temperature being too high may be: - Warm items were placed inside - Too much warm ambient air flowed in when rearranging and removing contents - Power failure for some time - The appliance is faulty. • The audible alarm is automatically silenced and the temperature display stops flashing when the temperature is sufficiently cold again. • If the door has been left open for more than 60 seconds, the alarm will sound. Pressing the POWER key once can switch off the audible alarm.
CARE AND MAINTENANCE CLEANING YOUR BEVERAGE MERCHANDISER • Turn off the power, unplug the appliance, and remove all items, including shelves. • Wash the inside and outside surfaces as well as the shelves with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth. • Wring excess water out of the sponge or cloth when cleaning the area where the controls are located, or any electrical parts. • Do not use steel wool or a steel brush on the stainless steel.
TROUBLESHOOTING You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. Troubleshooting Guide PROBLEM Appliance does not operate. POSSIBLE CAUSE • Appliance is not connected to a power source. • The appliance is turned off. • Tripped circuit breaker or a blown fuse. • The temperature is not set correctly. • The ambient temperature could require a higher thermostat setting.
Display “E0”, “E1”. “E2”, “E3”, “E4”, “E5” or “E7”. The alarm sounds and the temperature display flashes. The icon “--” is lit up and flashing in the temperature display. • “E0” indicates a communication error for 3 zone models. • “E1” or “E2” indicates that the air temperature sensor has failed. • “E3” or “E4” indicates that the defrost sensor in the evaporator has failed. • “E5” indicates defrost heater failure. • “E7” indicates door switch failure.
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.