Use and Care

Reversing the door swing

This appliance has the capability of the door opening from either the left or right side. The unit is

delivered to you with the door opening from the left side. Should you desire to reverse the opening

direction, please follow the instructions below:

1. Carefully lay the appliance on its back. Use cushioning to protect the floor and appliance.

2. With the door shut, remove the two screws holding the bottom hinge to the door.

3. Carefully lift off the door.

4. Unscrew the top hinge pin and cover and move to the opposite side.

5. Find the new bottom hinge provided in the plastic bag inside the appliance.

6. Place the door back onto the wine cellar, lining up the top hinge pin.

7. Connect the new bottom hinge pieces to the door and cabinet, using the screws from the

opposite side and following the same placement.

8. Keep the spare hinge, in case you ever want to set the door back to its original position.

Installing the handle

To install the handle, follow these instructions:

1. Carefully pull the door gasket (seal) away from the door in the area where the handle will be

attached.

2. Place the handle over the screw holes on the outside of the door and attach it with the screws

that have been provided. Tighten the screws.

3. Press the door gasket back into its groove.

OPERATION

Recommended temperatures for chilling wine

Red Wines: 15 – 18

C (59 – 64.4

Dry / White Wines: 9 – 14

C (48.2 – 57.2

Sparkling Wines: 5 – 8

C (41 – 46.4

These temperatures may vary slightly depending on whether or not the interior light is ON or OFF,

and whether the bottles are located on the upper/middle or lower section.