BEVERAGE MERCHANDISER Model No.: SCR1505 Instruction Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS. Write Serial No. (on back of unit) here: ________________________________ Felix Storch, Inc. 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
TABLE OF CONTENTS Appliance Safety ......................................................................... 3 Important Safeguards ................................................................ 3-4 Special Cautions ......................................................................... 5 Location of Parts ........................................................................ 6 Handling & Transport ................................................................. 6 Unit Review & Inspection .
APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words "DANGER" or "WARNING".
Do not connect or disconnect the electric plug when your hands are wet. Unplug the appliance or disconnect power before cleaning or servicing. Failure to do so can result in electrical shock or death. Do not attempt to repair or replace any part of your appliance unless it is specifically recommended in this manual. All other servicing should be referred to a qualified technician.
SPECIAL CAUTIONS DO NOT step on the front louver panel of your unit or use it as a step. ONLY use polarized plugs to plug in your unit. DO NOT CUT OR REMOVE the ground connection on the electrical cable. CHECK that the electrical system is grounded BEFORE plugging in refrigerator for the first time. The polyurethane in your unit contains cyclopentane gas as a foaming agent. When repairing, DO NOT use other types of polyurethane or mix the existing polyurethane with other types.
LOCATION OF PARTS Lighted header Light switch Internal fan Interior lighting (around door) Adjustable shelves (4) Handle Security lock Glass door Static condenser (on back of unit) Ventilation louvers Thermostat control Compressor and fan (behind louvers) Leveling legs HANDLING & TRANSPORT DO NOT MOVE UNIT WITH PRODUCT INSIDE as loose product can break, spill, damage the appliance, etc.
UNIT REVIEW & INSPECTION This refrigerator was completely inspected before leaving the factory. Check for signs of damage when the unit is received. If there is any damage, contact your authorized distributor or manufacturer immediately.
INSTALLING SHELVES Your refrigerator contains 4 wire shelves and 16 shelf clips. To install shelves, first place the shelf clips in the slots in the pilasters in the cabinet interior. Use the numbers on the pilasters as a guide in placing the clips at the same distance from the cabinet floor, with the tab pointing up as shown. Once all clips are in place, install the shelves by placing them on the clips, with the outside bar of the shelf on the inside of the clip tabs.
Wiring Diagram for model SCR1505: REFRIGERATION & LIGHTING SYSTEM The compressor in your SUMMIT refrigerator is designed to function silently. DO NOT plug in the unit immediately after moving it or changing its position. Allow a minimum of 1 hour for the pressures inside the refrigeration system to equalize and the oils in the compressor to settle. After plugging the unit in, let it run for one more hour without load or product. The refrigerator may then be loaded.
TEMPERATURE CONTROL The temperature is controlled by a thermostat which is located on the left side of the ventilation louvers, below the door. The thermostat has been factory-set to keep the product between 37.4 and 44.6°F (3 and 7°C). At night, or during long periods of inactivity, the appliance goes into an energy-saving mode, which keeps the temperature between 42.8 and 50.0°F (6 to 10°C).
CLEANING THE COMPRESSOR / FAN COMPARTMENT The compressor and fan are located behind the front louvers of the appliance. DISCONNECT THE UNIT’S POWER SUPPLY BEFORE REMOVING THE FRONT LOUVER to avoid accidents that may be caused by oscillation of the blade of the fan motor. Door Front louvers Compressor Screws Fan To clean the compartment behind the front louvers, 1. Disconnect the power supply to the appliance. 2. Remove the two screws, as shown above. 3.
TROUBLESHOOTING You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer. Troubleshooting Guide PROBLEM The unit does not operate. The unit is not cold enough. Turns on and off frequently. The light does not work. Ice forms on evaporator. Vibrations The unit seems to make too much noise. The door will not close properly. Excessive condensation in interior and on door.
LIMITED WARRANTY PARTS AND LABOR WARRANTY INFORMATION SUMMIT Appliances are manufactured to provide outstanding value, and your satisfaction is our goal on every product. All SUMMIT major appliances carry a one year limited warranty on both parts and labor. All refrigerators and freezers carry an additional four years on the compressor. Certain exclusions may apply. Certain models (including SUMMIT ranges, wall ovens, and cook tops) are manufactured for us in the U.S.
IMPROPER USE: SUMMIT assumes no liability for parts or labor coverage for component failure or other damages resulting from improper usage or installation or failure to clean and/or maintain product as set forth in the warranty packet provided with the unit.
