Use & Care

4
6. Remove the top right hinge and keep in a safe place in case you want to reverse the door in the
future.
7. Remove the screws from the top left and transfer to the right.
8. Install the top left hinge.
9. Install the bottom left hinge to the door. Do not over-tighten the screw.
10. Place the door back on the appliance, lining up the top hinge.
11. Install the bottom support bracket.
12. Adjust door alignment. When set, tighten screw on hinge.
13. Remove handle. Transfer the screw hole covers to the left and install the handle on the right.
OPERATION
Recommended temperatures for chilling wine:
Red Wines: 15 - 18
°
C (59 - 64.4
°
F)
Dry / White Wines: 9 - 14
°
C (48.2 - 57.2
°
F)
Sparkling Wines: 5 - 8
°
C (41 - 46.4
°
F)
These temperatures may vary slightly depending on whether or not the interior light is ON or OFF,
and whether the bottles are located on the upper/middle or lower section.
The Controls of Your Appliance
The appliance should be placed where the ambient temperature is between 16 and 35
°
C (61 - 95
°
F).
If the ambient temperature is above or below this range, the performance of the unit may be affected.
For example, placing your unit in an extremely cold or hot environment may cause the interior
temperature to fluctuate.
H, I, and J are the display lights for temperature settings. When H is lit, the interior temperature range
is 12~18ºC (54~64ºF); when I is lit, the temperature range is 7~11ºC (45~53ºF); when J is lit, the
temperature range is 1~6ºC (34~44ºF).
K is the light switch. The original setting has the light switch off. Press K once to turn on the light in
the compartment; press it once again to turn off the lighting. If the light is left on, after 20 minutes it will
automatically turn itself off.
L is the temperature display. When O or P is pressed, L shows the compartment temperature as it is
being set. Five seconds after O or P is pressed, L will show the actual temperature in the
Control Panel