Owner's Manual

Page 10
melting snowflake snowflake
Up & Down arrows
“SET” key
DIGITAL THERMOSTAT INSTRUCTIONS
You may choose to have a digital thermostat installed at the factory
to replace the standard manual (dial) thermostat. If your appliance
has a digital thermostat and you find it necessary to change the tem-
perature setting, please refer to the following instructions. The front
panel of the thermostat is illustrated here:
To see the SETPOINT:
Push and immediately release the SET key. The display will show
the SET point value. Wait 5 seconds and the probe value will display
again.
To change the SETPOINT:
Push and hold the SET key for more then 3 seconds to change the
set point value. The value of the set point will be displayed, and the
“snowflake” LED will start blinking.
To change the SET value:
Push the Up or Down arrows to the desired setting. The new setting
will be memorized after 15 seconds, provided no other keys are
pushed.
NOTE: The minimum/maximum range of your thermostat is preset
and locked by us, so it cannot easily be accidentally moved be-
tween freezer and refrigerator temperatures. To reset this range
lock, either call us or find information on our website under Trou-
bleshooting.
NOTE: Due to supply considerations, different digital thermostats
may be used with slightly different procedures. Refer to the
Troubleshooting section of www.summitapplianceparts.com for
the exact procedure.
Felix Storch, Inc. www.summitmedicalrefrigerators.com
Page 11
OPERATION MODES
SUMMIT’s optional High/Low Temperature Alarm boxes
have two operating modes: NORMAL DISPLAY MODE and
ALARM DISPLAY MODE. To change from one mode to
another, press the MODE button once.
NORMAL DISPLAY MODE – is indicated by the display of
current temperature and the MIN (minimum) and MAX
(maximum) temperatures. These temperatures relate to
external (probe) temperature if the probe is plugged in,
and to ambient temperature if the sensor probe is removed.
ALARM DISPLAY MODE – is indicated by the display of current
temperature and the HI and LO alarm settings. These temperatures relate
to external (probe) temperature if the probe is plugged in, and to
ambient temperature if the sensor probe is removed.
SETTING THE HIGH/LOW
TEMPERATURE ALARM BOX
1. Press the MODE button until the
unit is in the ALARM DISPLAY
MODE indicated by the display of
current temperature and HI and LO
alarm settings.
2. To set the HIGH temperature alarm
limit, press the HI button (on back
of control box) to advance the
display in 1° increments, until the
desired high temperature is
displayed. Press and hold the HI
button to rapidly advance the
display in 5° increments.
3. To set the LOW temperature alarm
limit, press the LO button (on back
of control box) to advance the
display in 1° increments, until the desired low temperature is
displayed. Press and hold the LO button to rapidly advance the
display in 5° increments.
ALARM
The unit can sound the alarm in both NORMAL DISPLAY MODE and
ALARM DISPLAY MODE. Slide the ALARM ON/OFF switch to ON. When
the current temperature display rises above the HI set point, or falls
ALARM INSTRUCTIONS (Selected Models)
www.summitmedicalrefrigerators.com Felix Storch, Inc.