Owner's Manual

ManualsBrandsSummit ManualsAppliancesAccuCold Series All Refrigerator, in Stainless Steel

Page 8

Base Grill (some models only)

To remove and replace the base grill:

1. Open the appliance door and remove the base grill by pulling down

and out from the top.

2. Replace the base grill by putting the clips in the openings in the

appliance panel. Push in until the base grill snaps into place.

Changing the light bulb (some models only)

NOTE: Not all appliance bulbs will fit your appliance. Be sure to replace

the bulb with one of the same size, shape, base size and wattage.

You can purchase bulbs from www.summitapplianceparts.com

1. Unplug appliance or disconnect power.

2. Remove the light shield. Most models do not require tools.

3. Replace the light bulb with an appliance bulb of the same wattage.

4. Replace the light shield.

5. Plug in appliance or reconnect power.

Loss of Power

After the power is restored, unplug the appliance for 30 minutes to

allow the refrigeration system to equalize. During this time keep the

door closed whenever possible.

REMEMBER: A full appliance stays cold longer than a partially filled

one.

Moving the Appliance

1. Remove all containers from inside the appliance.

2. Unplug the appliance.

3. Clean it thoroughly.

4. Tape the appliance shut and tape the electrical cord to the cabinet.

When you get to the new location, refer to the “Installation Instructions”

and “Appliance Use” sections for information on installation and re-

setting the unit.

APPLIANCE OPERATION

Felix Storch, Inc. www.summitmedicalrefrigerators.com

Page 13

Factory set default password: The factory set default password is 0123. If the

default password is lost, press the key (located inside

the battery box) for 30 seconds then wait for the warning

sound which signifies the factory set default password has

been restored.

To set the password

: While door is open press the key

(located inside the battery box) until it jingles, enter the 0123

password then # within 10 seconds to confirm. Enter the

password (1-16 digits) then press # again to confirm. A total of 10 passwords

can be set. NOTE: Each password starts from the number 0 to 9 in order. The

first password starting with 0 is the default password. For example, use 1xxx,

then 2xxx, etc., for up to 10 users.

Changing password

: While the door is open, press the key (located inside

the battery box) until it jingles, enter the old password and press # within 10

seconds to confirm. Enter new password then press # to confirm. NOTE: The first

digit cannot be changed.

To open the door

: While the door is closed, press the key, enter the

password, then press again to confirm.

To lock door manually

: Press #.

Function setting of automatic lock

: To set the auto-lock time, press the

key (inside the battery box); enter a number (any number between 10 and 99,

inclusive) then press # to confirm. The auto-lock time can be set between 10 and

99 seconds after opening the door. If the time is set less than 10 seconds, the

door will not lock automatically, only manually.

Deleting the door-opening passwords

: Press the key, enter default

password followed by 0000, then press # and all the door-opening passwords

will be deleted except for the default password.

NOTE: To access the battery box you need to remove only the two small screws

on the top and bottom of that cover. Do not remove the 4 screws holding the

keypad and cover to the appliance door.

KEYPAD LOCK (Optional on most models)